Kohler RUBICON 20147T-4 User manual

1357262-2A-B 1 1357262-2A-B 4
BEFORE YOU BEGIN
All information is based on the latest product information available at the time of publication. Kohler Co. reserves
the right to make changes in product characteristics, packaging, or availability at any time without notice.
Please leave these instructions for the consumer. They contain important information.
NOTE:
1. Flush the water supply pipes thoroughly to remove debris.
2. For new installations, install the faucet to sink before installing.
3. The highest working pressure for sprayhead is 0.5MPa(5bar). If it exceeds 0.5MPa(5bar), a pressure reducer is
needed. The highest water and environment temperature is 60ºC. Please keep sprayhead away from heater, or it
may become damaged and cause injury to the user.
HANDLE OPERATION
Open the handle gently. Turn clockwise for cold water, turn counter clockwise for hot water.
INSTALLATION INSTRUCTIONS
20147T-4 Pull-down Kitchen Faucet
RUBICON
20147T-4 Pull-down Kitchen Faucet
RUBICON
ROUGH-IN DIMENSIONS
SERVICE PARTS
**Color code must be specified when ordering
1357260**
1256962
1345961
1357249**
1357251**
1259310
1259250
1357363**
1256948
1196248
1357367
1357366
1259247
1363649
1357365
1256965
1357258**
1357256
1359292
1357257
64 Max.
Ø59
119
425
268
641
80
H
C55 229
13º
90º
25º
285
Ø33~Ø38
G1/2"

1357262-2A-B 2 1357262-2A-B 3
INSTALLATION
2. Partially thread the screws(2) into
the ring(3) until they extend 6mm
out the opposite side.
5. Connect and tighten the supply
hoses(6). The hose with blue mark
is connected to cold water.
3. Slide the washers(4) onto the
shank(5) and thread the ring onto
the shank.
6. Turn on the water supplies. Flush
the hot and cold water for about one
minute.
1. With the water running, rub the nozzles to dislodge
debris.
Faucet Maintenance: 2. To improve the flow, disconnect the sprayhead and
clean the screen washer. Reassemble.
1. Install the gasket(1), foam side
down. Install the faucet, the handle
is located on the right side.
4. Position the screws on the ring
onto the shank. Tighten the screws.
8. Align and connect the spray hose
to the connector.
9. Position the weight as shown
and tighten securely.
7. Loosely attach the weight(8) to
the spray hose(7).
11. Adjust the weight as needed for
proper positioning and operation.
10. Check for smooth operation.
INSTALLATION CHECKOUT
Ensure that all coupling nuts are tight. Ensure that the lever handle is in the off position. Turn on the main water
supply and drain, and check for leaks. Repair as needed.
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could adversely
affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
"LEAD FREE" is marked on the back of the faucet signifying its compliance with the United States AB1953
6mm
6
6mm
2
3
8 7
51mm~76mm
Tab
Connector
1
Metal Rubber
4
5