Korg Volca Nubass Use and care manual

volca nubass System Firmware Update Instructions
1
System Firmware Update Instructions
Do not playback the system update file on any speaker or headphone system as this could lead to
damage to equipment and/or hearing loss. Korg or any of its affiliates will not accept responsibility for
any damages, personal loss or injury that may result from playback of the file.
What you will need
You will need the following to perform your update.
⚫An audio player or personal computer capable of audio playback
⚫A stereo mini-jack audio cable
⚫AC adapter KA-350 or six AA batteries
Make sure the batteries are brand new if using alkaline or fully charged if using NiMH batteries.
volca nubass will not enter update mode if the batteries are depleted.
Preparations
1. Unzip the file “volca_nubass_updater_0104.zip”.
If using an audio player, transfer the file volca_nubass_sys_0104.wav from your computer to your
audio player.
Do not playback the system update file on any speaker or headphone system as this could lead
to damage to equipment and/or hearing loss.
2. Check the current version
Turn the power on while pressing the PLAYbutton. The display will indicate the current version of the
main and panel systems in the following format:
“1.02” : main system version 1.02
“P0.09”: panel system version 0.09
Pressing the PLAY button will continue the startup process normally.

volca nubass System Firmware Update Instructions
2
3. Connect the audio output of your playback device to the SYNC IN connector on your volca nubass.
Perform the update
1. Turn the power on while pressing the FUNC and PLAY buttons.
“UPdt” will appear on the display to indicate that volca nubass is in update mode.
2. Start the playback of volca_nubass_sys_0104.wav to begin updating.
Make sure the volume of the playback device has been turned up.
STEP LEDs 1-16 will indicate the update progress.
Make sure the update file is played from the beginning.
When using a computer, any other system sounds (e.g. email notification) will cause the update
to fail. Make sure all other applications are shut down and do not operate your computer during
the update.

volca nubass System Firmware Update Instructions
3
The update will take approximately 6 minutes and a half. Do not turn your volca nubass off or
stop playback while update is in progress.
If the update fails, all the knob LEDs will start blinking. If this happens, observe “Tips”at the end
of this document and repeat the update from step 1.
3. When the update has successfully completed, “End.” will appear on the display. Now, turn the
power off.
4. Go back to step 2 of “Preparations”and check that your volca nubass has been updated by verifying
the current system version.
Tips
⚫Update may fail with some audio players, computers or software. If this is the case, please try with a
different device.
⚫If you are having trouble with the update, please check the following:
Make sure the volume of the playback device has been turned up.
Please note that some devices which have very high output levels may fail because of it. If this
is the case please try turning the volume down and start the update process again.
Make sure all functions that affect the playback sound, such as cross-fade and EQ, are
disabled.
Make sure the update file is played from the beginning.
Check the connection from your playback device to your volca nubass.
When using a computer, any other system sounds (e.g. email notification) will cause the update
to fail. Make sure all other applications are shut down and do not operate you computer during
the update.