
4
BUFFERED/TRUE BYPASS switch
is switches between ultra-buer bypass and true bypass.
e ultra-buer circuit expands the dynamic range of the sound, which helps
prevent the sound from thinning out when you use longer cables or multiple
pedals.
True bypass outputs the input audio as-is, without changing the sound in any way.
Tuning procedure
1. Press the TUNER ON/OFF switch to activate the tuner.
e LED meter or the note name display lights up.
e signal from the INPUT jack will not be output from the BYPASS jack.
Tip: e TUNER ON/OFF switch only functions if an instrument is connected
to the INPUT jack.
2. If necessary, set the reference pitch and the display mode. (page 5
“Reference pitch settings”, page 6 “Display mode settings”)
3. Play a single note on your instrument and tune it so that the desired note
appears in the note name display.
e note name closest to the entered note appears in the note name display.
4. Tune your instrument using the tuning LED meter.
e method for indicating whether your instrument is in tune, sharp or at
depends on which display mode you choose (page 6 “Display mode
settings”).
5. Aer you nish tuning your instrument, press the TUNER ON/OFF switch to
turn the tuner o.
e LED meter or the note name display goes dark. e signal from the INPUT
jack is outputted to the BYPASS jack.
Tip: e reference pitch, display mode and bright mode settings will be
preserved even if you remove the AC adapter.
Tip: To reset the settings to the factory defaults (reference pitch = 440 Hz,
display mode = regular, bright mode = brighter), hold down the CALIB
button and press the TUNER ON/OFF switch when you turn on the
tuner.