Kramer KRT-4-LAN User manual

KRT-4 Quick Start
P/N:
2900- 301470QS
Rev:
3
Scan for full manual
KRT-4 Quick Start Guide
This guide helps you install and use your KRT-4 for the first time.
Go to www.kramerav.com/downloads/KRT-4 to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
KRT-4 Cable Retractor
3 M4x50 screws
WCP (KRT) insert kit
Step 2: Get to know your KRT-4
KRT-4 is available for the following cables:
HDMI™, VGA, audio (3.5mm), LAN,
USB-3.0, MDP/H (up to 4K30Hz), 3H2
(HDMI extender) and DisplayPort. Refer to
www.kramerav.com/product/KRT-4 for the
updated configuration list.
#
Feature
Function
1
Retractor Enclosure
Contains the retractable cable mechanism.
2
Fixed Cable Female Connector
Connect to a male connector under the table.
3
Fixed Cable End
Short connector cable.
4
Screw Openings for Mounting Under the Table (3)
Use to attach the KRT-4 directly under a table.
5
Wing-Head Thumb Screw
Use to turn and lock KRT-4 to the TBUS enclosure.
6
TBUS Installation Slot
Insert TBUS enclosure side into the slot to attach KRT-4 to a TBUS.
7
Retracting Cable
Pull to connect to a connector above the table.
8
Retracting Cable Male Connector
Connect to a female connector.
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
Step 3: Install KRT-4
Use this procedure to mount KRT-4 onto the following Kramer TBUS units: TBUS-1AXL, TBUS-3xl, TBUS-4xl, TBUS-5xl, TBUS-6xl
and TBUS-10XL and so on.
•Before mounting the KRT-4 onto a TBUS, you need to configure and install the TBUS inner frame (including inserts and
power sockets) and mount the TBUS onto a table.
•Remember to prepare an opening in the TBUS inner frame
for the retracting cable connector (for example, use the
Kramer WCP pass-through insert).
•Ensure that the environment (e.g., maximum ambient temperature
& air flow) is compatible for the device.
•Avoid uneven mechanical loading.
•Appropriate consideration of equipment nameplate ratings should
be used for avoiding overloading of the circuits.
•Reliable earthing of rack-mounted equipment should be
maintained.

To attach KRT-4 to a TBUS:
1. From under the table, slide the KRT-4 onto one of the
side walls of the TBUS.
Make sure that the fixed cable is directed downwards
and the retracting cable is directed upwards.
2. Use the wing-head thumb screw to fix the KRT-4 firmly in
place and pass the retracting cable end through the
cable pass-through bushing.
The KRT-4 is now firmly fixed in place.
Attaching KRT-4 (as a Standalone) to the Underside of a Table
The thickness of the table should be at least 18mm so as not
to damage the table. Kramer Electronics is not responsible
for any damage caused to the table.
To attach KRT-4 to the underside of a table:
1. Place the KRT-4 under the table in the desired location.
Make sure that the retracting cable faces the edge of the
table.
2. Pass the 3 M4x50 screws through the table screw
openings and tighten them to fix the retractor under the
table.