Kramer MTX3-16-M User manual

MTX3 Modular Matrix Card Quick Start
P/N:
2900- 301634QS
Rev:
1
Scan for full manual
MTX3 Modular Matrix Card Installation Quick
Start Guide
This guide helps you install the MTX3 Modular Matrix Card.
Step 1: Check what’s in the box
MTX3 Modular Matrix Card
Step 2: Get to know your Modular Matrix Card
The attached card mounts in one of the slots on the rear of the chassis:
•In MTX3-16-M, matrix cards are installed horizontally, and slots are numbered from top to bottom (1 to 8 and 9 to 16).
•In MTX3-34-M, matrix cards are installed vertically, and slots are numbered from left to right (1 to 34).
Input and output cards may be mounted in any slot.
Step 3: Install a matrix card
To install a matrix card to the MTX3 Modular Matrix Card (as shown in the example below):
1. Power off the machine and all devices connected to it.
2. Using a Phillips screwdriver, loosen the screws at the top and bottom (or sideways) of a blank plate.
3. Remove the blank plate from the slot and store it for possible future use.
4. Remove the new card from its shipping box and anti-ESD bag.
5. Holding the card by the lower handle, align the card with the plastic guide rails (vertical or horizontal).
6. Slide the card into the chassis until the front of the card contacts the connector inside the chassis.
7. Press the card firmly into the slot until the connector
plate is flush with the rear panel of the chassis and the
connector is fully seated.
8. Using a Phillips screwdriver, tighten the retaining
screws at the top and bottom of the card to secure it to
the chassis.
9. Power on the machine and follow the procedure in
the user manual to configure the new card.
10. Power on the peripheral devices.
For optimum range and performance use the recommended
Kramer cables available at www.kramerav.com.
Using third-party cables may cause damage!
Safety Instructions
Caution: There are no operator serviceable parts inside the unit.
Warning: Use only the power cord that is supplied with the unit.
Warning: Do not open the unit. High voltages can cause electrical shock! Servicing by qualified personnel only.
Warning: Disconnect the power and unplug the unit from the wall before installing.