Krystufek PAN MV-690 User manual

Instruction Manual
PAN MV-690
Electrical Tester
Dipl.Ing. Ernst KRYSTUFEK GmbH & Co KG
AUSTRIA, 1230 Vienna, Pfarrgasse 79
Tel: +43/ (0)1/ 616 40 10
Fax: +43/ (0)1/ 616 40 10 – 21
www.krystufek.at
[e-mail]

Beeping
24
_
+
12
VDC
6
+ VDC -VD C
_+
24
6
12
VDC
-VD C+ VDC
230
690
400
48
110
12
24
VAC
VAC
Electrical Tester
Instruction Manual
Safety Information
Never use the tester if it or its test leads appear damaged.
Never apply more than 1000V DC or 1000V AC rms. between any
terminal and earth ground.
It is indicates terminals dangerous voltage present if the LED turns
on.
When using the probes, do not touch the metal probe tips.
Disconnect the live test lead before disconnecting the common test
lead.
Before each use, verify the tester’s operation by measuring a known
voltage.
Automatic Operation
The tester automatically turns on when you place the probes across a
complete circuit. The tester selects continuity or DC or AC voltage mode
based on the resistance or voltage between the probes. The tester
automatically turns off when you remove the probes from the complete
circuit.
Measuring Voltage
Connect test leads across the source or load under measurement, the
LED turned on at between 70% and 100% of their rated voltages.
DC Voltage AC voltage
220V DC maximum 690V rms. Maximum 45 Hz to 66 Hz
Testing for Continuity
Turn off circuit power before testing. Beeper indicates shorts lasting 1ms
or longer
OPEN short or 0-85KΩ
Specifications
Function Range Accuracy
AC voltage (V) 12,24,48,110,230,400,690 -30% to 0% of reading
DC voltage (V) 6,12,24,36,48,110,220 -30% to 0% of reading
Continuity test: Audible threshold 0-85kΩ, Continuity beeper 2KHz
Maximum Voltage Between any Terminal and Earth Ground:
1000V DC; 1000V AC rms, Overvoltage Category III
Input Impedance: 1MΩ
Altitude: Operating: 3000m; Storage: 10,000m
Relative Humidity: 90%(0-30); 75%(30-40); 45%(40-50)
Battery Type and Life: AA (2); 350 hours with NEDA 15F or IEC R6
Safety: Complies with EN61010-1:1993 for use in over voltage CAT III
environments
EMC Regulations: EN50081-1, EN50082-1
Battery Test and Replacement
Replace the batteries when touching the leads together no longer turns
on the continuity LED.
2xAA
Disconnect probes Do not
from Voltage over-tighten screws