KTMED NEPLUS Configuration guide

Cleaning info
STEP 1
STEP 2
Quick
Cleaning
(After use)
Acessories
Cleaning
(After use)
1) After filling with water until half
full, gently shake it. Dispose of
residual medication.
2)Nebulize for 60 sec after filling
with clean water. Warm water is
better.
1)Gently shake the parts in run-
ning water
2)Right after cleaning, remove
water with gauze(paper towels)
and dry them completely.
1) Gently shake medication
bottle(mesh cartridge) in warm
water or room temperature water
for 5 seconds.
2)Right after cleaning, remove
water with gauze(paper towels)
and dry it completely.
1) Disinfect the parts including
mask by dipping in hot
water(100°C) for 1 minute.
2)Right after disinfecting, remove
water with gauze(paper towels)
and dry them completely.
60 sec
5 sec
Cleaning
(If necessary)
Acessories
Disinfecting
(If necessary)
For service or to purchse parts, please contact local distributor or our compay.
www.ktmed.com
100°C

Caution
STEP 1
STEP 2
Quick
Cleaning
(After use)
Acessories
Cleaning
(After use)
Never use a disinfection solution
including hypochlorite solution.
For cleaning, use only clean
water.
Do not clean medication bottle
(mesh cartridge) in running water.
Do not clean the main unit with
water.
Do not put the main unit(battery
cover) in wet place.
Frequent cleaning may cause
damage of the part.
O-ring of medication bottle cap
could be missing during cleaning.
Do not dip over 5 seconds.
Wrong position of battery
cover causes the unit not to work.
Check proper battery polarity
when inserting one.
60 sec
5 sec
Cleaning
(If necessary)
For service or to purchase parts, please contact local distributor or our company.
www.ktmed.com
Correct position
of Battery cover
O-ring