KUSSMAUL EURO CHARGER II 24/12 User manual

091-138T EUROCHARGER II 24/12
LUDO McGURK SVE
UNIT 3 CROSSFIELD ROAD, HANDFORTH, CHESHIRE, SK9 3LN.
TEL: [phone]
WEB: www.ludomcgurk.co.uk
FAX: [phone]
EMAIL: [e-mail]
- 1 -
INSTALLATION GUIDE AND MANUAL
EURO CHARGER II
24/12
AUTOMATIC BATTERY CHARGER
3 YEAR WARRANTY
NOTE :
This charger is designed for vehicles with dual electrical systems,
one 24 volt and another 12 volt, common negative ground.
Made in U.S.A. by
KUSSMAUL ELECTRONICS CO., INC.
Distributed in Europe by
LUDO McGURK TRANSPORT EQUIPMENT LTD
WILMSLOW - U.K.

091-138T EUROCHARGER II 24/12
LUDO McGURK SVE
UNIT 3 CROSSFIELD ROAD, HANDFORTH, CHESHIRE, SK9 3LN.
TEL: [phone]
WEB: www.ludomcgurk.co.uk
FAX: [phone]
EMAIL: [e-mail]
- 2 -
INTRODUCTION
The Euro Charger II 24/12 Battery Charger is a compact completely automatic charger designed for
installation on vehicles with a 24 volt main system and a 12 volt auxiliary battery. Two separate
outputs are provided to charge the two sets of batteries separately. Voltage is sensed for each
battery so that each battery is charged according to its requirements. The total output to the two
sets of batteries is 15 amperes. An ammeter provides continuous indication of the charger output.
Construction of the Euro Charger II 24/12 is extremely rugged to withstand the shock and vibration
normally encountered by vehicle mounted equipment. The unit operates completely automatically
and stops charging the batteries when they are fully charged. There is no trickle charge and
therefore no danger of overcharging and water boil-off. Any parasitic loads on the battery such as
radio, lights, etc., are automatically supplied with current by the charger.
INSTALLATION
The Euro Charger II 24/12 Automatic Battery Charger should be installed in an area with adequate
ventilation.
1. Mount the charger using the four holes provided for this.
2. Connect the wiring from the batteries to the Output Terminal Strip.
3. Connect the wiring to the batteries. Ring lugs that have been securely crimped, or
soldered, should be used.
4. Double check all wiring before proceeding.
5, Caution: Verify that the dual voltage switch (DV switch) and the fuse on the front panel
corresponds to the applied voltage. For fuse size, see chart on page three or four.
6. Wire the A.C. power to power input terminal strip.
7. Pilot light will light to show that the charger has power.

091-138T EUROCHARGER II 24/12
LUDO McGURK SVE
UNIT 3 CROSSFIELD ROAD, HANDFORTH, CHESHIRE, SK9 3LN.
TEL: [phone]
WEB: www.ludomcgurk.co.uk
FAX: [phone]
EMAIL: [e-mail]
- 3 -
INSTALLATION WIRING DIAGRAM
FUSE
POWER
INPUT
OUTPUT
L
N
+
+
24v
12v
Line
Neutral
Ground
A.C. Input Power
Chassis
Ground
Chassis
Ground
Chassis
Ground
230
CAUTION
Be certain that DV switch and
fuse correspond to input voltage.
Input Voltage Fuse
230VAC 6 Amp
115VAC
12 Amp
IMPORTANT: Charger output wire size is 4mm². Wire size is for a maximum length of 3 metres. If
wiring is to be longer, larger wiring is required. Additional information is available on request.

091-138T EUROCHARGER II 24/12
LUDO McGURK SVE
UNIT 3 CROSSFIELD ROAD, HANDFORTH, CHESHIRE, SK9 3LN.
TEL: [phone]
WEB: www.ludomcgurk.co.uk
FAX: [phone]
EMAIL: [e-mail]
- 4 -
SPECIFICATION & OUTLINE
Input Fuse: see chart
Output Voltage: 24V/12V
Output Current: 15 Amps
Charge Indicator: 0-15 amps 5%
Weight: 7.5 kgs
Input Voltage Input Current Fuse
230VAC 50/60 hz 2.7 Amps 6 Amp
115VAC 50/60hz 5.3 Amps
12 Amp
WARRANTY
All products of Kussmaul Electronics Company Inc. & Ludo McGurk Transport Equipment Ltd. are
warranted to be free of defects of material or workmanship. Liability is limited to repairing or
replacing at our factory, without charge, any material or defects which become apparent in normal
use within 3 years from the date the equipment was shipped. Equipment is to be returned; shipping
charges prepaid and will be returned, after repair, shipping charges paid.
Kussmaul Electronics Company, Inc. & Ludo McGurk Transport Equipment Ltd shall have no
liability for damages of any kind to associated equipment arising from the installation and /or use of
the Kussmaul Electronics Company, Inc. & Ludo McGurk Transport Equipment Ltd products. The
purchaser, by the acceptance of the equipment, assumes all liability for any damages, which may
result from its installation, use or misuse, by the purchaser, his or its employees or others.