9
But standard of a nipple with a hole differs according to the area and a manufacturer
and if the size is not correct, you will order it separately.- We accept a request in the A/S
center.)
Warning-You wrap the tape for preventing the leakage 4~5 times not to harm on the
connection between nipple and piping and after complete connection, you have to adjust
the direction of a valve not to make a problem on the connection with the product.
You link the switch valve with the nipple with a hole connected in 3) as shown
in the figure.
Warning-You wrap the tape for preventing the leakage proper times not to harm on the
connection between nipple and piping and after complete connection, you have to adjust
the direction of a valve not to make a problem on the connection with the product.
(As shown in the figure, after stopping down the nipple, the switch valve will be horizontal
so you control the amount of leakage tape as the same amount.)
Insert the hose stop down nut at the hose and push the hose in the switch valve at the end.
After that connect the hose stop down nut with switch valve and stop down with proper
strength.
Warning-If you stop down the nut too strong, the water will be possible to leak because
the hose in the hose stop down nut can be torn. Or if you stop down the nut too loose,
the water will leak because the hose is missed from the switch valve.
So you connect the hose safely by giving the proper strength carefully.
How to connect with the product after connecting the hose with a tap pipe
After selecting the proper place for the product, cut the length of hose with some extra to
the product. As shown in the figure, remove a rubber plug in the raw water inlet and put
the hose in the raw water inlet. At this time, you put the hose at the end not to miss from
the product.
Power cord Water drain outlet
Water supply inlet
