Kyocera FS-C8026N Operating instructions

Removing paper jams from your FS-C8026N printer
The figure below explains the printer’s paper paths including the options, for
example, the document finisher and the duplexer. The locations where paper
jams might occur are also shown here. Paper jams can occur in more than one
component on the paper paths.
Jams in the Paper Feeder
1.When a paper jam occurs in the printer or
installed paper feeder as it leaves the cassette,
open the right cover and remove the paper.
Jams in the Paper Cassette
1. Pull out the paper cassette and remove the
jammed paper.

2. If you cannot remove the jammed paper as
shown in step 1, remove the paper cassette
from the printer.
3. Pull the jammed paper from inside the printer.
Jams in the Mp Tray
1. Remove the jammed paper on the MP tray up and
towards the right.
2. Reset the sheets on the MP tray.
3. Open and close the front cover to notify the printer
of he completion of jam removal.
Jams in the Duplex Unit
1.Pull out the duplex unit.
2.Open the top cover of the Duplex Unit and
remove the jammed paper.

3.Pull the lever on the bottom of the Duplex Unit
towards you, and open the bottom cover.
4.Remove the jammed paper.
5.Close the bottom cover and top cover.
6.Slide the Duplex Unit back into the printer.
Jams in the Right Cover
1. Pull the paper transfer unit handle and pull the
unit out to the right.
2. If the jammed paper is in the paper transfer
unit, remove it.
3. Push the green lever on the bottom of the
transfer unit in the direction indicated by the
arrow, and open the right cover.

4. Remove the jammed paper.
If the end of the paper is soiled with toner, pull
it in the direction indicated by the arrow to
remove it
5. Pressing the handle of the transfer unit, return
the transfer unit securely to its original position.
Jams in the Paper Feed Unit
1. Pull out the paper cassette.
2. Pull out the paper feed unit.
3. Raise the lever, and then remove the jammed
paper.
4. Return the paper feed unit back into the printer,
and then close the paper cassette.

Push the paper feed unit in until it locks in
place with a click.Return the paper transfer
unit back into the printer.
Jams in the Paper Feed Unit
CAUTION: The fuser unit and rollers become very hot
during normal use. Never touch them with your hands.
1. Open the left cover, and then rotate the green
knob to remove the jammed paper.
2. If you cannot remove the jammed paper this
way, pull the two green lock levers towards you
and then open the fuser unit cover.
3. While rotating the green knob, remove the
jammed paper.
4. If you still cannot remove the jammed paper,
close the fuser unit cover. While raising the
green lever at the bottom of the fuser unit, pull
the fuser unit out of the printer.
5. Remove the jammed paper from behind the
fuser unit.
6. Return the fuser unit back into the printer, and
then close the left cover.