La Crosse Technology WCLTV-WSDR1 User manual

Replace Wind Cups or Directional Vane
on Cyclone and Glide Sensors
Cyclone Sensor Glide Sensors
Wind Cups Model: WCLTV-WSDR1 (Fits Glide and Cyclone sensors)
Wind Directional Vane Model: WVLTV-WSDR1 (Fits Cyclone Sensors)
Replace Wind Vane - Cyclone Sensors
1. Remove the old wind vane with the screwdriver. Take note of the flat edges located on
the post of the Sensor and inside of the Wind Vane. Align the flat edges and place the new
Wind Vane on the the post of the Sensor.
Tool Required: Mini screwdriver with Phillips head (not included).

Replace Wind Cups (Same instructions for both types of sensors)
1. Remove the old wind cups with the
screwdriver. Take note of the flat edges
located on the post of the Sensor and
underside of the Wind Cups.
3. Carefully tighten the screw on the side
of the cups using a mini screwdriver. The
screw should tighten into the flat edge of
the post.
2. Align the flat edges and place the new
Wind Cups on top of the Sensor.
4. When the screw is tight, gently pull up on
the cups to ensure they are secure.
If they pull o, start again with step two.
2. Carefully tighten the screw on the side of the vane using a mini screwdriver. The
screw should tighten into the flat edge of the post. When the screw is tight, gently pull on
the vane to ensure it is secure.
Tool Required: Mini screwdriver with Phillips head (not included).