La Crosse 919-186-60WH User manual

CUBE TIMER
Models: 919-186-60WH & 919-186-30BLK
DC: 081618
Check out our SUPPORT tabs: bit.ly/919-186-60wh & bit.ly/919-186-30blk
Timer OFF
(0 on top)
Timer 5 Minutes
(5 on top)
ACTIVATE/DEACTIVATE CUBE TIMER
1. Install 2 AAA batteries according to polarity
markings.
2. Move ON/OFF Switch to ON position.
3. Select your timer duration by flipping the cube
until you see your desired time on top. The
countdown will begin automatically.
4. To stop the timer, flip the cube so the 0 is on
top.
5. When not in use, make sure to move the ON/
OFF Switch to the OFF position to conserver
battery power.
AAA
AAA
Pre-AL LED
OFF
ON
Page 3 Page 4 Page 2
Minutes
Seconds
Alarm
Volume
Batteries
2-AAA
ON/OFF Switch
Pre-AL
LED
ON/OFF

WARRANTY INFO
La Crosse McCormick, LLC. provides a 2-year limited warranty
(from the date of the original consumer purchase), on this product
against manufacturing defects in materials and workmanship. Send
$5.00 with date and proof of purchase to the following address.
Please include the model number of your product and your
complete address and phone number. La Crosse McCormick,
Warranty Department, 2830 26th St. St., La Crosse, WI 54601.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
WARNING: This product can expose you to chemicals
including styrene, which is known to the State of
California to cause cancer. For more information go to:
www.P65Warnings.ca.gov
CARE + MAINTENANCE
• Do not mix old and new batteries
• Do not mix Alkaline, Lithium, standard, or rechargeable batteries
• Always purchase the correct size and grade of battery most suitable for
intended use
• Clean the battery contacts and also those of the device prior to battery
installation
• Ensure the batteries have the correct polarity (+ / -)
• Remove batteries from equipment that will not to be used for an extended
period
• Promptly remove expired batteries.
SPECIFICATIONS
Time Duration: 919-186-60WH Preset 5, 15, 30 or 60 minutes
919-186-30BLK Preset 5, 10, 15 or 30 minutes
Power: 2-AAA batteries not included
Dimensions: 2.36 inch square (6 cm square)
LED BUTTON
• The red LED light is set to on by default, and
will stay on to indicate an active timer.
• Press the LED button to turn this “min” light ON
or OFF.
Note: When manipulating the timer, you’ll hear
movement inside. This is the inner tilt sensor
adjusting your timer’s LCD orientation.
ALARM VOLUME (OFF-LOW-HIGH)
• Adjust your alarm volume using the slide switch
located under the batteries inside the battery
compartment. This can be set to HIGH, LOW, or
OFF.
OFF HIGHLOW
ALARM DURATION
• The default alarm duration is 30 seconds, after
which it will shut o automatically.
• Press the Pre-Al button to give out a 10 second
warning. An indicator will appear to the right of
the minutes when Pre-Al is activated.
Page 7Page 5 Page 6 Page 8