Lacertosus MA2-32 SELEKTOR User manual

OK
Bar end
Male connector
32
NO!
2
32
1
Before use
STEP 1 - FIG. A STEP 2 - FIG. B
STEP 3 - FIG. C STEP 4 - FIG. D
STEP 5 - FIG. E FIG. F
Regularly inspect the general condition of the dumbbell and check the points listed.
The dumbbell can only be adjsted when in the base unit.
Female and Male connectors must align, see FIG F.
Never attempt to lift the dumbbell from the
base unit if not fully selected position, see FIG. B.
Carefully inspect Male and Female connections
(see FIG. A) regularly. replace before use, if damaged.
Regularly check if the locking mechanism is working
in all dierent weight selections, see FIG. D. never use
dumbbell if the handle can be turned with normal force
when not in a base unit.
Never attempt to use the dumbbell without having
the complete set of weights plates in the base.
After use
Place the dumbbell in the base unit.
Female and Male connectors must be alligned.
Select weight by turning the handle until desired
weight is centered in the window.
Lift the dumbbell straight up out of the base unit.
Place the dumbbell on at surface. Try turning the
handle with normal force. The handle must remain
in loked position. Check that the bar ends are
within 5mm of the selected place
After use return the dumbbell to base unit. Make
sure that the Male/Female connectors are aligned.
Make sure that the Male/Female connectors are
aligned. Do not use if connectors are damaged.
thank you for choosing

MA2-32 SELEKTOR
MAIL: [email protected] VISIT: WWW.LACERTOSUS.COM
PER LE ISTRUZIONI IN ITALIANO: