laerdal Little Anne QCPR User manual

Little Anne QCPR
User Guide
EN

Table Of Contents
Introduction 3
Features 3
Additional Information 3
Items Included 4
Setup 5
Unpacking 5
Inserting The Batteries 6
Preparing The Manikins 7
Connecting To QCPR App 12
Logging Into QCPR App 12
Connecting To The Application 12
SkillGuide Connection 16
Repacking 18
Maintenance And Cleaning 23
Lungs Replacement 23
Face Skin Cleaning 23
Chest Skin Cleaning 23
2

Introduction
Little Anne is a manikin designed for CPR, compressions and mouth-to-mouth venti
lation training. It enables real time feedback and debriefing via the QCPR App on any
device: phone, tablet or laptop.
Features
The manikin has the following features:
• Head tilt,
• Jaw thrust,
• Nose pinching.
Additional information
• This product can be used with the SkillGuide device.
• This product can be used with QCPR App.
• How-to videos for this product are available here.
Introduction
3

Items included
• 6 manikins
• 6 face skins
• 60 single-use filters
• 6 front skulls
• 6 back skulls
• User Guide
• 2 AA batteries
Introduction
4

Setup
Unpacking
1. Open the suitcase and take the manikins out.
2. Place the manikins on the floor.
Setup
5

Inserting the batteries
1. Flip the manikin on its chest.
2. Open the battery hatch.
3. Insert the batteries inside the hatch and over the ribbon.
Note
Make sure the battery ribbon is correctly positioned before in
serting the batteries. This will make it easier to remove them
when needed.
Setup
6

4. Close the battery hatch.
5. Repeat for the other manikins.
Note
• Use 2 AA batteries on this product.
• Dispose of and recycle in accordance with the local legislation.
Preparing the manikins
1. Open the pouch located at the bottom of the suitcase to find the front skulls.
Setup
7

2. Clip the front skull to the back skull.
Setup
8

3. Flip the face skin inside out.
4. Clip the single-use filter in the filter holder inside the face skin.
Setup
9

5. Place the single-use filter in the mouth opening of the front skull and spread the
face skin on the whole face.
6. Attach the face skin on each ear to secure it. Make sure the face skin covers the
chin and is properly attached to the ears.
Setup
10

7. Do one chest compression on the manikin to turn it on.
The manikin beeps once.
Note
The manikin turns off automatically after:
• 10 minutes if the manikin is not connected to QCPR App.
• 60 minutes if the manikin is connected to QCPR App.
To turn the manikin back on, do one chest compression.
Setup
11

Connecting to QCPR App
Logging into QCPR App
Information on how to download and log into the application are available in this
article.
Connecting to the application
1. Log into QCPR App.
The training modes page opens.
Connecting to QCPR App
12

2. Select a training mode.
3. Check that the Bluetooth is on and turn it on if needed.
Connecting to QCPR App
13

4. Turn on the manikin.
Note
Additional information on how to turn on the manikin is available
on this screen.
Connecting to QCPR App
14

5. Select your manikin(s) from the list that appears.
6. Select Continue.
The selected manikins are connected.
Connecting to QCPR App
15

SkillGuide Connection
1. Flip the manikin on its chest and locate the cable connector on the right side.
2. Route the SkillGuide cable through the neck.
Caution
Make sure to route the cable this way so as not to damage the
cable.
3. Connect the SkillGuide cable to the manikin.
SkillGuide Connection
16

4. Flip the manikin on its back.
5. Turn on the manikin.
6. Repeat these actions on all remaining manikins.
Note
For more information on how to connect to SkillGuide, refer to the
SkillGuide User Guide.
SkillGuide Connection
17

Repacking
After the training sessions are complete, repack the manikins:
1. Unplug the face skin from each side of the face to detach it.
Repacking
18

2. Flip the face skin inside out and remove the single-use filter.
Note
• The single-use filters must be changed after every class.
• Dispose of and recycle in accordance with the local legislation.
3. Put the face skins back in their bag.
Repacking
19