DISPLAY AND CROWN/BUTTON OPERATION
Stopwatch second hand
(Move in second increments)
Button (A) * In stopwatch function Start/Stop
Crown at normal position
Crown at extended position *Time setting
Button (B) * In stopwatch function Split/Split release/Reset
Stopwatch minute hand
(Move in minute increments)
Second hand
Hour hand
Minute hand
*The measured time is indicated by the stopwatch hands that move independently of the center and 24-hour hands.
ADJUSTING THE STOPWATCH HAND POSITION
Before setting the time, check if the Stopwatch second and minute hands are at the “0” (12 o’ clock) position.
If the stopwatch is in use, press the button in the following order to reset it, and then, check if the hands return to “0” position.
24-hour hand
(Indicates the time on a 24-hour basis)
If the stopwatch is counting: (A) (B)
If the stopwatch is stopped: (B)
If the split time is displayed: (B) (A) (B)
*If either of the stopwatch hands are not at the “0” position, reset them following the procedure below:
Crown
1. Pull out the crown
Stopwatch second hand
Stopwatch
minute hand A
B
2. Press button (A) or (B) to reset the stopwatch
second and minute hands to “0” position
*By pressing button (A), the hands move counter
clockwise
*By pressing button (B), the hands move clockwise
3. Push the crown back to the
normal position
TIME SETTING
*Before setting the time, check that the chronograph measurement is stopped.
2. Pull out the crown when the
second hand is at the 12
o’clock position. The second
hand will stop on the spot.
*Do not press any button.
Otherwise, the chronograph
hands will move.
2. Turn the crown to set the
hour, minute and 24-hour
hands to the desired time.
As the hour hands moves,
the 24-hour hands also
moves correspondingly.
When setting the hour hand,
check that the 24-hour hand
is set properly.Otherwise,
the chronograph hands will
move.
3. Push the crown back in to the
normal position in accordance
with a time signal.
