Lane KONA 60581-87-01 User manual

R
ASSEMBLY INSTRUCTIONS
ITEM # : 60581-87-01 KONA CNTR HGT TABLE WHITE
Page 1 of 4 MADE IN VIETNAM

R
ITEM # 60581-87-01
KONA CNTR HGT TABLE
60581-87-01 PARTS & HARDWARE LIST
Please assemble with the tool provided or recommended. Do not use an impact drill.
H1
A
TABLE TOP x 1
H2
LEGS x 4
H3 H4
B
ALLEN BOLT x 8
(Ø5/16'' *60mm)
SPRING WASHER x 8
(Ø5/16'' )
FLAT WASHER x 8
(Ø5/16'')
ALLEN KEY x 1
(M4)
Customer Service Contact Information:
Toll Free Phone Number: 1-844-771-2727
Email: [email protected]
Website: www.lanefurniture.com
NOTES :
1. CHECK CAREFULLY FOR SMALL PARTS WHICH MAY COME LOOSE DURING SHIPMENT.
2. REMOVE ALL COMPONENTS FROM THE PACK AND PLACE ON A CLEAN, SOFT SURFACE TO ASSEMBLE.
3. UNITS SHOULD BE ASSEMBLED BY TWO OR MORE PEOPLE.
4. DO NOT OVER - TIGHTEN SCREW/ BOLTS UNTIL ASSEMBLY IS COMPLETED.
5. WITH USE, SCREW/ BOLT MAY BE COME LOOSE & MUST BE TIGHTENED PERIODICALLY.
Page 2 of 4
TEAM
LIFT
MADE IN VIETNAM
For Your Safety!

R
ITEM # 60581-87-01
KONA CNTR HGT TABLE
HARDWARE BLISTER PACKS ARE STORED ON THE TOP OF THE TABLE BASE
HARDWARE
PACK
B
A
Customer Service Contact Information:
Toll Free Phone Number: 1-844-771-2727
Email: [email protected]
Website: www.lanefurniture.com
NOTES :
1. CHECK CAREFULLY FOR SMALL PARTS WHICH MAY COME LOOSE DURING SHIPMENT.
2. REMOVE ALL COMPONENTS FROM THE PACK AND PLACE ON A CLEAN, SOFT SURFACE TO ASSEMBLE.
3. UNITS SHOULD BE ASSEMBLED BY TWO OR MORE PEOPLE.
4. DO NOT OVER - TIGHTEN SCREW/ BOLTS UNTIL ASSEMBLY IS COMPLETED.
5. WITH USE, SCREW/ BOLT MAY BE COME LOOSE & MUST BE TIGHTENED PERIODICALLY.
Page 3 of 4
TEAM
LIFT
For Your Safety!
MADE IN VIETNAM

R
ITEM # 60581-87-01
KONA CNTR HGT TABLE
STEP 1 (x1)
Do not over-tighten the bolts.
Make sure you use the lock
washers to ensure the bolts stay
fastened.
MDF CORNER
SUPPORT B
B
H3
H2
H1
H4
AA
TABLE ASSEMBLY COMPLETED
Page 4 of 4 MADE IN VIETNAM