Lanier Magenta Toner for 5706/5806 117-0288 Operating and maintenance instructions

Lanier Worldwide, Inc.
2300 Parklake Dr., N. E.
Atlanta, GA 30345-2979
Emergency Telephone: [phone]
MATERIAL SAFETY DATA SHEET
Section 1: Chemical Product and Company Information
Identity: Magenta Toner for 5706/5806 MSDS No. CP-320
Product ID: 117-0288 Issued: 11/29/00
Synonyms
& Common
Names:
Uses:
Chemical
Formula:
Magenta Toner for
Lanier 5706, 5806, 5625, 5631
Lanier 5706, 5806, 5625, 5631 Digital Color
Copier
Mixture
Supersedes:
Date:
Prepared by:
Approved by:
European Contact:
5/6/99
11/29/00
Lanier Worldwide, Inc. 770-496-9500
Larry Choskey, Manager, Corp. EH&S
Lanier Worldwide Inc.,
Walter Fricke, Manager, Safety &
Environment
Im Taubental D-41468 Neuss, Germany
[phone]
Section 2: Composition / Information on Ingredients
PERCENT CAS No. EXPOSURE LIMITS SOURCE
Polyole resin 88 –93 186359-26-2Not listed n/a
Organic pigment 4.0 –8.0 980-26-7Not listed N/a
Organic salt 1.0 –5.0 42405-40-3Not listed N/a
*PEL as the product: 15mg/m3(total dust), 5mg/m3 (respirable dust)
*TLV as the product: 10mg/m3(total dust), 5mg/m3 (respirable dust)
Section 3: Hazards Identification
HMIS Rating:
FLAMMABILITY = 1 HEALTH = 1
REACTIVITY = 0 SPECIAL = none
Health Hazards (Acute, Chronic, Immediate and Potential):Minimum irritation to respiratory tract may occur as with exposure to any non-
toxic dust. May cause gasping if inhaled. Inhalation should be avoided. May cause temporary eye discomfort.
Health Hazards of Long Term exposure (Chronic): n/a
This product contains no known hazardous materials as defined by the OSHA Hazard Communication Standard 29 CFR 1910.1200.
Section 4: First Aid Measures
Inhalation: Remove to fresh air if effects occur. Gargle with water. Get medical attention if needed. Eye Contact: In case of contact, immediately flush eyes with water for 5 minutes. Get medical attention if
needed.
Skin Contact: Wash with soap and water. Ingestion: Dilute stomach contents with several glasses
of water. Get medical attention.
Section 5: Fire Fighting Measures
Suitable extinguishing media: CO2, dry chemical, foam or water.
Extinguishing media which may not be used for safety reasons: none
This material will burn in case of fire. The decomposition products are CO, CO2, and Nox. Avoid inhalation of smoke.
Special protective equipment for fire fighters: none
UEL: 45 mg/L LEL: n/a Section 6: Accidental Release Measures
Spill / leak Procedures: If spilled, sweep up using an approved toner vacuum with a 0.5 micron filter or smaller, such as the Atrix AAA Toner
Vacuum or 3M Toner Vacuum. Use of a vacuum cleaner not rated for toner particles, could result in a fire or personal injury. Remove residue
with soap and cold water.
Miscellaneous: Keep product out of sewers and watercourses.
Personal protection: Avoid inhalation of dust. Section 7: Handling and Storage
Special Handling: Cleanse skin after contact before breaks or meals, and end of workday.
Special Storage: Store in a cool, dry place. Avoid direct sunlight. Keep out of reach of children.

MATERIAL SAFETY DATA SHEET
Page 2of CP-320
Information on this data sheet represents our current data and best opinion as to the proper use in handling of this product under normal conditions.
On the basis of the data available to us, this product is not a dangerous substance. One should, however, observe the usual precautionary measures
for dealing with chemicals.
Miscellaneous: Do not handle in windy areas. Flying powder may enter eyes. Minimize inhalation of dust. Cleanse skin thoroughly
after contact, before breaks and meals, and at end of work periods.
Section 8: Exposure Control and Personal Protection Information:
Respiratory Protection: none required under normal use. Hand Protection: none required under normal use.
Eye Protection: none required under normal use.
Ventilation: Local exhaust equipment is needed. Skin Protection: none required under normal use.
Section 9: Physical and Chemical Properties
CHARACTERISTICS:
Appearance: Magenta Melting point: Approx. 110°C
Form: Powder Vapor pressure: n/a
Odor: Slight plastic odor Vapor density: n/a
Solubility in Water: Insoluble Evaporation rate: n/a
Bulk density: ~1.2 Boiling point: n/a
Section 10: Stability and Reactivity
Conditions to avoid: none Materials to avoid: none Stability: Stable
Hazardous decomposition products: CO and CO2 and other decomposition products when burned.
Section 11: Toxicological Information:
Ames test negative Acute oral toxicity: (rat) 5g/kg
Section 12: Environmental / Ecological Information
None
Section 13: Disposal Consideration
Used Toner should be disposed of under conditions that meet all federal, state and local environmental regulations. Disposal regulations vary
from locality to locality, therefore consult your local Lanier office or the EPA to determine the proper method for disposal. Do not incinerate loose
or spilled Toner.
Section 14: Transportation Information
None. This is not a hazardous product.
Section 15: Regulatory Information
none
Section 16: Miscellaneous Information
Judgment as to the suitability of information contained herein for user’s purposes is the responsibility of the purchaser. Therefore, although
reasonable care has been taken in the preparation of this information, Lanier Worldwide, Inc.extends no warranties, makes no representations,
and assumes no responsibility as to the accuracy or suitability of such information for application to user’s intended purposes or for
consequences of its use. All materials may present unknown hazards and should be used with caution. Although certain hazards are
described herein, we do not guarantee that these are the only hazards that exist.