Lanier Cyan Developer B2309660 Operating and maintenance instructions

Lanier Worldwide, Inc.
2300 Parklake Drive, NE
A
tlanta, GA USA 30345-2979
MATERIAL SAFETY DATA SHEET
Emergency Telephone: [phone]
Section 1: Chemical Product and Company Information
Identity:
Cyan Developer
MSDS No.
CP- 771
Product ID: B2309660 Issued: 07/05/2006
Synonyms
& Common
Names:
Uses:
Chemical
Formula:
Developer, Cartridge Cyan
Lanier LD425c, LD430c
Mixture
Supersedes:
Date:
Prepared by:
Approved by:
none
10/19/2005
EH&S Department 770-496-9500
Larry Choskey, Manager, CHS
Section 2: Composition / Information on Ingredients
PERCENT CAS No. EXPOSURE LIMITS SOURCE
Ferrite 75 – 95 65997-18-4 Not listed N/a
Polyester resin 1 – 20 Confidential Not listed N/a
Organic pigment < 1 147-14-8 Not listed N/a
Section 3: Hazards Identification
HMIS Rating:
FLAMMABILITY = 1 HEALTH = 1
REACTIVITY = 0 SPECIAL = none
Health Hazards (Acute, Chronic, Immediate and Potential): product is stable, nonflammable powder. If used as intended the
product does not present an acute or chronic health hazard.
Health Hazards of Long Term exposure (Chronic): no data is available on this product.
Carcinogenicity: This product does not contain the carcinogenic substances, which are listed in NTP, IARC, and are regulated by
OSHA. Section 4: First Aid Measures
Inhalation: Remove to fresh air if effects occur. Get medical
attention if needed.
Eye Contact: In case of contact, immediately flush eyes
with water for 15 minutes. Get medical
attention if needed.
Skin Contact: Wash with soap and water. Wash clothing before
reuse. If irritation occurs or is persistent, seek
medical attention.
Ingestion: Dilute stomach contents with several
glasses of water. Get medical attention if
needed.
Section 5: Fire Fighting Measures
Suitable extinguishing media: CO2, dry chemical, foam or water
fog.
Extinguishing media which may not be used for
safety reasons: none
Special protective equipment for fire fighters: none
UEL: n/a LEL: n/a Unusual fire or explosion hazards: Dust of this product
at sufficient concentrations can form explosive mixtures
with air.
your document management partner

MATERIAL SAFETY DATA SHEET
Page 2of 3CP-771
Section 6: Accidental Release Measures
Spill / leak Procedures: If spilled, sweep up using an approved toner vacuum with a 0.5 micron filter or smaller, such as the Atrix
AAA Toner Vacuum or 3M Toner Vacuum. Use of a vacuum cleaner not rated for toner particles, could result in a fire or personal
injury. Remove residue with soap and cold water.
Miscellaneous: Keep product out of sewers and watercourses.
Personal protection: Avoid inhalation of dust.
Section 7: Handling and Storage
Special Handling:
Cleanse skin after contact before breaks or meals, and end of workday.
Do not handle in areas where the wind blows.
Minimize the breathing of dust.
Special Storage:
Avoid direct sunlight. Keep out of reach of children. Store in a cool, dry place. Below 35C (95F)
Section 8: Exposure Control and Personal Protection Information:
Respiratory Protection: none required under normal use. Hand Protection: none required under normal use.
Eye Protection: none required under normal use. Skin Protection: none required under normal use.
Section 9: Physical and Chemical Properties
CHARACTERISTICS:
Appearance: Cyan Melting point: N/a
Form: Powder Vapor pressure: N/a
Odor: Slight plastic odor Vapor density: N/a
Solubility in Water: Insoluble Evaporation rate: N/a
Specific gravity: ~ 5 g/cm3Boiling point: N/a
Section 10: Stability and Reactivity
Conditions to avoid: none Hazardous decomposition products: will not occur
Polymerization: none
Section 11: Toxicological Information:
Ames test: negative
Acute oral toxicity: > 5000mg/kg
Carcinogenicity: no data is available on this product.
Teratogenicity: not available
Section 12: Environmental / Ecological Information
Bioaccumulation: Not known in bioaccumulation
Environmental degradation: not known
Section 13: Disposal Consideration
Used developer should be disposed of under conditions that meet all federal, state and local environmental regulations. Disposal
regulations vary from locality to locality; therefore consult your local Lanier office or the EPA to determine the proper method for
disposal. Do not incinerate loose or spilled developer.

MATERIAL SAFETY DATA SHEET
Page 3of 3CP-771
Section 14: Transportation Information
International regulations:
RID/ADR Not applicable ICAO-TI/ATA-DGR Not applicable
DOT 49 CFR Not applicable UN Classification Number Not applicable
ADNR Not applicable IMDG Code Not applicable
Specific precautionary transport measures: Avoid direct sunlight. Do not keep over 35°C (95°F).
Product label: Developer Cyan B2309660
Section 15: Regulatory Information
Regulation: No information available
Section 16: Miscellaneous Information
Judgment as to the suitability of information contained herein for user’s purposes is the responsibility of the purchaser.
Therefore, although reasonable care has been taken in the preparation of this information, Lanier Worldwide, Inc. extends no
warranties, makes no representations, and assumes no responsibility as to the accuracy or suitability of such information for
application to user’s intended purposes or for consequences of its use. All materials may present unknown hazards and
should be used with caution. Although certain hazards are described herein, we do not guarantee that these are the only
hazards that exist.