Lanier T 6055 Black Toner 117- 0098 Operating and maintenance instructions

Lanier Worldwide, Inc.
2300 Parklake Dr., N. E.
Atlanta, GA 30345-2979
Emergency Telephone: [phone]
MATERIAL SAFETY DATA SHEET
1
Section 1: Chemical Product and Company Information
Identity: T 6055 Black Toner MSDS No. CP-239
Product ID: 117-0098 Issued: 1/5/01
Synonyms
& Common
Names:
Uses:
Chemical
Formula:
Toner, Black Toner
M6055, 6155, 6260, 6360 Copier
Mixture
Supersedes:
Date:
Prepared by:
Approved by:
European
Contact:
8/7/95
01/05/01
EH&S Department 770-496-9500
Larry Choskey, Manager, CEH&S
Lanier Worldwide, Inc.
Walter Fricke, Manager, Safety &
Environment
Im Taubental D-41468 Neuss,Germany
[phone]
Section 2: Composition / Information on Ingredients
PERCENT CAS No. EXPOSURE LIMITS SOURCE
Styrene acrylate copolymer 90 27136-15-8Not listed N/a
Carbon black 41333-86-43.5mg/m3 3.5mg/m3OSHA PEL ACGIH TLV
Polypropylene wax 49003-07-0Not listed N/a
Organic pigment 284179-66-8Not listed N/a
*PEL as the product: 15mg/m3 (total dust), 5mg/m3 (respirable dust)
*TLV as the product: 10mg/m3 (total dust), 5mg/m3 (respirable dust)
Section 3: Hazards Identification
Hazard Rating:
FIRE = 0 HEALTH = 0
REACTIVITY = 0 SPECIAL = none
Health Hazards (Acute, Chronic, Immediate and Potential): Minimum irritation to respiratory tract may occur as with exposure to any
non-toxic dust. May cause gasping if inhaled. Inhalation should be avoided. May cause temporary eye discomfort.
Health Hazards of Long Term exposure (Chronic): A manufacturer sponsored chronic inhalation study in rats using a special test
toner revealed there were no lung changes at all in the lowest exposure level (1mg/m3), the most relevant level to potential human
exposures. A very slight degree of fibrosis was noted in 25% of the animals at the middle exposure level (4mg/m3), while a slight
degree of fibrosis was observed at the highest exposure level (16mg/m3) in all animals. These findings are attributed to “Lung
Overloading”, a generic response to excessive amount of any dust retained in the lungs for a prolonged interval. The special test
toner was ten times more respirable than commercially available toner to comply with EPA testing protocol and would not function
properly in Xerographic equipment. Section 4: First Aid Measures
Inhalation: Remove to fresh air if effects occur. Consult
local medical personnel
Eye Contact:In case of contact, immediately flush eyes with
water for 5 minutes.
Skin Contact:Wash with soap and water. Ingestion:Rinse mouth with water. Call a physician.

MATERIAL SAFETY DATA SHEET
Page 2of CP-239
Information on this data sheet represents our current data and best opinion as to the proper use in handling of this product under normal conditions. On
the basis of the data available to us, this product is not a dangerous substance. One should, however, observe the usual precautionary measures for dealing
with chemicals.
Section 5: Fire Fighting Measures
Suitable extinguishing media: CO2, dry chemical, foam or water.
Extinguishing media which may not be used for safety reasons: none
This material will burn in case of fire. The decomposition products are CO, CO2, and Nox. Avoid inhalation of smoke.
Special protective equipment for fire fighters: none
UEL: n/a LEL: n/a
Section 6: Accidental Release Measures
Sweep up or clean up with an approved toner vacuum.
Section 7: Handling and Storage
Special Handling: none
Special Storage: No special storage requirements for safety reasons. Store in a cool dry place.
Section 8: Exposure Control and Personal Protection Information:
Respiratory Protection: none required under normal use. Hand Protection: none required under normal use.
Eye Protection: none required under normal use. Skin Protection: none required under normal use.
Section 9: Physical and Chemical Properties
CHARACTERISTICS:
Appearance: Black Melting point: N/a
Form: Fine powder Vapor pressure: n/a
Odor: Practically odorless Vapor density: n/a
Solubility in Water: Negligible Evaporation rate: n/a
Specific gravity: 1.1 Boiling point: n/a
Section 10: Stability and Reactivity
Conditions to avoid: none Materials to avoid: none Stability: Stable
Hazardous decomposition products: CO, CO2, and NOx when burned.
Section 11: Toxicological Information:
Acute oral toxicity (rat) LDLO: Over 5.0 g/kg Ames Test result: Negative
Carcinogenicity: In 1996, the IARC reevaluated carbon black as a GROUP 2B carcinogen (possible human carcinogen). This evaluation is given to
carbon black for which there is inadequate human evidence, but sufficient animal evidence. The latter is based upon the development of lung tumors
in rats receiving chronic inhalation exposures to free carbon black at a level that induce particle overload of the lungs. Studies performed in mice
have not demonstrated an association between carbon black and lung tumors. Moreover, a two-year cancer bioassay using a typical toner
preparation containing carbon black demonstrated no association between toner and tumor development in rats.
Section 12: Environmental / Ecological Information
None
Section 13: Disposal Consideration
Waste material may be dumped or incinerated under conditions, which meet all federal, state and local environmental regulations.
Section 14: Transportation Information
None
Section 15: Regulatory Information
None
Section 16: Miscellaneous Information

MATERIAL SAFETY DATA SHEET
Page 3of CP-239
Information on this data sheet represents our current data and best opinion as to the proper use in handling of this product under normal conditions. On
the basis of the data available to us, this product is not a dangerous substance. One should, however, observe the usual precautionary measures for dealing
with chemicals.
Judgment as to the suitability of information contained herein for user’s purposes is the responsibility of the purchaser. Therefore, although
reasonable care has been taken in the preparation of this information, Lanier Worldwide, Inc. extends no warranties, makes no representations, and
assumes no responsibility as to the accuracy or suitability of such information for application to user’s intended purposes or for consequences of its
use. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein, we do not
guarantee that these are the only hazards that exist.