Lanpro LP-1521 User manual

Wireless - Equipment
www.lanpro.com
LP-1521 Broadband AP Router. 123 Manual,
Restoring to factory settings, (with PoE).
LP1521_M123_ENI01W
LP-1521 Broadband AP Router.
123 Manual
Restoring to factory settings,
(with PoE).

www.lanpro.com
Wireless - Equipment - 2.4 GHz - LP-1521 Broad Band AP Router, Restoring to factory settings, with PoE.
2
Please check the package contents, please see Figure 1.
1
Figure 1
Wait until the equipment stabilizes. Locate a small
hole in the back of the LP-1521 marked with the
word: Reset, press the switch behind the hole with
a non-metallic pin during 5 to 10 seconds as shown
in figure 6.
6
Figure 7
Screw the antenna as shown in figure 2.
2
The LP-1521 can be powered in three different ways:
A.-Via passive PoE: through any of the following
ports: WAN, LAN1 and LAN4 . The RJ45 Pins used
are: Pin 5 ( -12 VDC) and Pin 7 (+12 VDC). You
must include a Passive Injector and a power converter
supplying between 12 and 22 VDC and power the
LP-1521 through distances up to 40 m.
B.-Via active PoE: you can use the LP-PoE150
injector and LP-PoE151 splitter made by Lanpro. This
arrangement will let you put the LP-1521 as far as
100 m from the injector. You must set the splitter to
12 VDC and power the LP-1521 through the power
Jack.
C.- Via the Jack placed at the right of the LAN4 port.
We have provided with this kit a way to power the
LP-1521 by using a 120 VAC to 12 VDC Power
Converter included in the box and shown in figure 5.
5
Connect your PC to a LAN port of the LP-1521 as
shown in figure 3.
3
Please connect the WAN port to your ISP as shown in
figure 4.
4
Figure 2
Figure 5
Figure 3
Figure 4
Release the pressure on the switch and wait ‘till there
is a complete reset of the equipment. Once stabilized,
please proceed to access it with your preferred browser
through the default IP address: 192.168.1.254 as
shown in figure 7.
7
Figure 6