Lanpro LP-N24 User manual

Wireless - Equipments
www.lanpro.com
123 Manual LP-N24 V2.0, 2.4 GHz Wireless-N Broadband Router
and/or Access Point (AP). Installation in Router and AP mode through WPS PBC.
LPN24V2_M123_ENK01W
123 Manual LP-N24 V2.0,
2.4 GHz Wireless-N
Broadband Router
and/or Access Point (AP).
Installation in Router and AP
mode through WPS PBC.

www.lanpro.com
2
Wireless - Equipments - 123 Manual LP-N24 V2.0 - 2.4 GHz Wireless-N Broadband Router
and/or Access Point (AP) - Installation in Router and AP mode through WPS PBC.
3
Screw the antenna as shown in Figure 2.
Connect to electric power as shown in Figure 3.
2
3
Figure 3
Figure 2
For this conguration, the client device must support WPS mode. Please check its features. In this typical conguration we
use LP-N24U as client.
1
Figure 1
Check the content of the box, as shown in Figure 1.

www.lanpro.com
3
Wireless - Equipments - 123 Manual LP-N24 V2.0 - 2.4 GHz Wireless-N Broadband Router
and/or Access Point (AP) - Installation in Router and AP mode through WPS PBC.
Press the RESET/WPS button at the rear of the
LP-N24 V2.0 for two seconds as shown in Figure 5.
Connect your Internet service to the WAN port, as shown in
Figure 4.
You will notice how the WPS LED ashes. (Please see Figure 6-1 and 6-2). From this moment you will have 2 minutes to
press the WPS button in the client device.
4
5
6
Figure 4
Figure 5
Figure 6-1 Figure 6-2

www.lanpro.com
4
Wireless - Equipments - 123 Manual LP-N24 V2.0 - 2.4 GHz Wireless-N Broadband Router
and/or Access Point (AP) - Installation in Router and AP mode through WPS PBC.
Wait approximately for 2 minutes while the client device
and the router negotiate. You will notice that your device
connects to the router. (Please see Figures 8-1, 8-2
and 8-3).
The conguration through WPS method is not always
assertive. Sometimes it must be repeated until the desired
connection result is obtained, as well as the generation of the
keys. In case any conguration inconvenience through this
process persists, we recommend you to use the traditional
conguration mode through AP mode and key assignment
manually.
The communication process between wireless devices for
the conguration through WPS in its two modalities, PBC and
PIN, depends on the external conditions of the environment
and the inuence they may have on the wireless signal.
8
7
Proceed to press the WPS button of the client device,
as shown in Figure 7.
Figure 7
Figure 8-1
Figure 8-2
Figure 8-3