Lantronix Xpress-Pro SW 52000 User manual

Part Number 900-508a 1
May 2007
XPress-Pro SW 52000 Quick Start
This quick installation guide describes how to install and use the hardened compact Ethernet Switch. Capable of operating at temperature extremes of
-10°C to +60°C, this is the switch of choice for harsh environments constrained by space.
Physical Description
The Terminal Block and Power Input
The Terminal Block
PWR Power Input
GND Power Ground
Earth Ground
DC Terminal Block Power Input: The DC Terminal Block power input can be used to power up this Switch.
The 10/100BaseTX and 100BaseFX Connectors
The 10/100BaseTX Connections
The following lists the pinouts of 10/100BaseT/TX ports.
Pin Regular Ports Uplink port
1 Input Receive Data + Output Transmit Data +
2 Input Receive Data - Output Transmit Data -
3 Output Transmit Data + Input Receive Data +
4 NC NC
5 NC NC
6 Output Transmit Data - Input Receive Data -
7 NC NC
8 NC NC
The 100BaseFX Connections
The fiber port pinouts
The Tx (transmit) port of device I is connected to the Rx (receive) port of device II,
and the Rx (receive) port of device I to the Tx (transmit) port of device II.

2
The Port Status LEDs
LED State Indication
10/100TX or 100FX
Steady
A valid network connection established.
LINK stands for LINK.
LINK/ACT
Flashing
Transmitting or receiving data.
ACT stands for ACTIVITY.
Steady The port is transferring at 100Mbps.
100
Off
The port is transferring at 10Mbps If this
LED is dark.
Functional Description
Support 802.3/802.3u/802.3x. Auto-negotiation: 10/100Mbps, Full/half-duplex; Auto MDI/MDIX.
100BaseFX: Multi mode SC and ST type; Single mode SC or ST type; WDM Single mode SC type.
Support 2K MAC addresses.
Store-and-forward mechanism.
Full wire-speed forwarding rate and non-blocking mechanism.
Broadcast storm filtering.
Operating voltage and Max. current consumption: 12VDC @ 0.71A, 24VDC @ 0.37A, 48VDC @ 0.22A. Power consumption: 10.56W Max.
Power Supply: DC Terminal Block power input, 10-48VDC.
Operating temperature ranges from -10℃to 60℃.
Plastic compact Din-rail industrial case design.
Assembly, Startup, and Dismantling
Assembly: Place the switch on the DIN rail from above using the slot. Push the front of the switch toward the mounting surface until it audibly snaps
into place.
Startup: Connect the supply voltage to start up the switch via the terminal block.
Dismantling: Pull out the lower edge and then remove the switch from the DIN rail.