Larson Electronics EXPFL-31 User manual

EXPFL-31
Explosion Proof Halogen Flashlight
Instruction Manual

1
Congratulations on the purchase of your new Handheld Waterproof
and Explosion Proof Flashlight. Please read these instructions
carefully to familiarize yourself with the safe operation and
maintenance of your new flashlight. Following these instructions will
insure many years of safe and dependable service.
Table of Contents
I. Operating Instructions 2
I.I Assembly 2
I.II Operation 2
II. Bulb Replacement 3
III. Warnings 4

2
Return to Table of Contents
I. Assembly and Operation
I. Assembly
Unscrew the lens cap and install approved 2
"AA" alkaline batteries. Once batteries have
been placed, screw the lens cap back on.
II. Operation
This flashlight features a simple push button
switch for easy operation. Operators press the
switch once to turn on and again to turn off.
Push Button Power Switch
- Lens Cap

3
Return to Table of Contents
II. Bulb Replacement
I. Replacement
Begin by unscrewing the lens cap of the flashlight.
The light housing is held together with the lens cap
by clicking into place. To separate the the housing
and the lens cap simply apply force and pull them
apart.
(Note: The bulb is held in place via a screw
attached to the lens, upon separation of the
housing and lens cap the bulb will be free, be
careful not to drop, lose, or break the bulb.)
The bulb is now free to be replaced.
Specifications
Power Source: 2 AA Cells
Bulb/Lamp: Xenon
Bulb/Lamp Life: 15 Hours
Light Output: 13,000 Beam Candlepower
Weight (Without batteries): 2.2 oz.
Replacement Bulb: XPR2AA #20350
Approximate Burn time during continuous use: 3 hours 30 min.
Approximate Burn time during intermittent use: 4 hours 30 min
Product Features
• UL Division 1 & 2 Listed
• Non-Conductive
• Passes 30 foot drop onto concrete
• 13,000 Candle Power
• Pushbutton Switch
• Pre-focused spot beam
• Key Ring
• Xenon Bulb
• Submersible to 100ft
• Pocket size
• Fits Helmet Clips

4
Return to Table of Contents
III. Safety Warnings and Ratings
For personal safety, always follow the safety instructions in this manual to ensure safe and long-
term use. Failing to do so can result in damage to the product or serious bodily injury.
I. Safety Warnings
Never place flashlight face down when light is
on or is still hot from recent use. Doing so could
burn/ignite surfaces such as seats, carpeting,
etc. and cause major property damage.Always
turn spotlight off when not
in use.
To prevent serious damage to eyesight, never
look into the flashlight when light is on. DO
NOT shine light into the face of someone else.
DO NOT touch the lens of the flashlight when
light is on or if it was recently on. The lens will
be hot and could cause serious burns.
DO NOT allow children to handle or operate
this flashlight.
DO NOT use this product for other than its
intended use.
DO NOT operate in close proximity of
combustible or flammable materials.
DONOTattempttooperatethisspotlightifcord,
plug, battery, bulb or any part of the spotlight is
damaged or corroded.
DO NOT remove lens ring.
DO NOT allow metal parts to touch metal
contacts on battery as this can cause a short
circuit and result in a fire.
II. Ratings
UL: Class I, Div 1, Group C & D / Class I, Div 2
Group A, B, C, D
Class II, Div 2, Group G
Operating Temp T3C
MSHA: Approved
Should further information not covered by these
instructions be required, please contact Larson
Electronics at 1-800-369-6671 or
[e-mail] for further
assistance.
Please visit LarsonElectronics.com for Warranty
and Return information.