Larson Electronics GL-8130-M User manual

GL-8130-M
We recommend that you fully read and understand this manual prior to operation.
Do not operate the RL-11-LED in an environment where flammable gases may be present.
Do not stare directly into the light or shine into another person’s eyes as this may cause
temporary loss of vision.
Do not let water enter the housing, since this light is only water resistant (IP55). It is not ideal for
submerging and diving.
If the RL-11-LED is damaged, please don’t turn the unit on until it is fully inspected by an
authorized service center.
Do not operate the RL-11-LED if the front lens is cracked or removed.
Never disassemble the RL-11-LED, as all parts must be factory serviced to insure proper
operation.
Do not store the light and/or battery in locations where the temperature may exceed 131°F
(55°C) or in high humidity locations.
Should the operating time show significant decrease (even after full charging), battery
replacement may be required.
If the RL-11-LED is to be stored for a long period of time or to prevent accidental operation,
remove the battery from the RL-11-LED.
Do not allow objects or skin to contact the aluminum alloy front housing because it becomes hot
after extended operation.
Do not operate the RL-11-LED during charging stage.
Do not charge any battery pack except “RL-11-BA” battery packs with the battery charger
supplied with your RL-11-LED.
Maintain battery’s life, it’s essential to charge it every 3 months.
Always allow battery to be fully charged. DO not operate a damaged charger or battery pack.
Do not try to repair a damaged LED searchlight, battery pack, or charger by yourself.
FEATURES
Flood lens that can easily change the beam pattern from Spot to Flood
4 Modes; High, Med, Low, and Strobe
Power the unit off can be done in any mode by holding the power button down for 2 seconds.
CHARGING
1. Fully charge the RL-11-LED before first use.
2. The RED LED on the battery pack will be illuminated when the battery is being charged.
3. Charging time 3-5 hours in RAPID charge and TRICKLE in 2 hours.
4. The GREEN LED on the battery pack will illuminate after RAPID charge is complete.
5. Please wait 2 hours TRICKLE time when RED LED turns to GREEN LED to insure battery pack is
fully charged.

RUN TIME
160 minutes at 100%
320 minutes at 50%
625 minutes at 25%
625 minutes in Strobe Mode
OPERATING
Power on:
1. Push the Power button once for full power –100% output
2. Press again for half power –50% output
3. Press again for quarter power –25% output
4. Press again for Flash
Power off:
1. Press and hold the Power button for 2 seconds in any mode.
MAINTENANCE
Periodically clean the surface with a cloth (moistened with mild detergent) and clean the front
lens after it has cooled with glass cleaner. Use of harsh chemicals/cleaners may cause
discoloration of the surface.
The RL-11-LED has been designed to be maintenance free. If any replacement parts become
necessary, please contact an authorized service center.
After continuous operation, please wait 30 minutes before recharging to prolong the life of the
battery pack.
To maintain the battery’s life, it’s essential to charge it every 3 months.
Remove the battery from the light when storing for extended periods of time.