Larson Electronics LED10W-1S-10.75C User manual

LED10W-1S-10.75C
Larson Electronics, LLC Phone: [phone] Fax: [phone] www.larsonelectronics.com
1of 32
10W LED Light - 900 Lumens - 2" Square - Stud
Mount - 9-48V - 10.75' 16/2 SOOW Cord w/ 2" Pigtail
Instruction Manual
About The Solstice Solo LED Light:
123
4
Qty: 1 Qty: 1
Qty: 1
Solstice Solo Pigtail Set Bolt
[2mm]
Allen Key
[2mm]
LIGHT WIRING PART (B1) Qty: 2
5
Qty: 1
Omni Link
PART (O1)
6
Qty: 1
Solo Mount w/
Nylock Nuts
PART (M1)
PART (A1)
FEATURES
1. Highest Light Output Per Cubic Inch on the Market
2. Less than 1 Amp Power Consumption
3. Omni-Link Interlocking System
SOLSTICE SOLO SERIES SPECIFICATIONS
1. Warranty
2. Amp Draw
: Extended
: 0.83A @ 12V DC
3. Input Voltage : 9-32V DC
4. Beam Patterns : 10°, 30°, 30°/65°, 60°
5. LED Lifespan : 50,000 Hours
PREPARATION
1. We recommend completely reading instructions before installing.
2. Consult your local state regulatory agency regarding the use of LED lighting.
3. The placement of LED lighting should not restrict airflow to the radiator, or block head
lamps, turn signals, or parking lights.

LED10W-1S-10.75C
Larson Electronics, LLC Phone: [phone] Fax: [phone] www.larsonelectronics.com 2of 2
WARNING: Bolts, Nuts, and Washers are Stainless Steel. DO NOT USE Pneumatic or Electric
Tools to Tighten and Loosen. The Hardware Will Permanently Lock Together.
MOUNTING INSTALLATION INSTRUCTION
1. First, attach Solo Mount to Light using provided Set Bolt(B1) and Allen Key(A1).
2. Next, place the light on the location where it will be mounted.
3. Determine where the Solo Mount bolt will be placed, and mark where the bolt location will be.
4. Drill a hole for the Solo Mount bolt.
5. Place the light over the hole, and then slide the bolt through the drilled hole.
6. Slide the Nylock Nut on the opposite side of the drilled hole, and fasten until properly secure.
4
OMNI-LINK INSTRUCTIONS (OPTIONAL)
1. Using the provided Omni Link (O1), slide the link into desired top or
side notch of the light.
2. Set in place using provided Set Bolt (B1) and Allen Key (A1).
3. Repeat using second light to link both lights together.
MOUNTING KEY
TIP: For complete application guide see website
1
1. Solo Mount
2. Bolt 2
3. Mounting Surface
4. Nylock Nut 5mm 3
COMPONENTS KEY
1.. LED Lig
2.. Pigta
3.. Wire to Power Sour
MAINTENANCE
1. All models have been designed for maintenance free use. In the case an LED lamp or other part
replacement is needed please contact Larson Electronics.
WIRING INSTALLATION INSTRUCTION
1. Supplied with the Solstice Solo is a 3” Pigtail.
2. Connect the positive (red) Pigtail wire to the positive wire of your power source. Repeat this step
for the negative Pigtail wire (black) as well.
3. Now that power is connected to the pigtail it is ready to plug into the LED light for use.
3
2
1