Laser SPK-LED690BLK User manual

Backpack LED RGB Party Speaker with Tripod
SPK-LED690BLK
User Manual

WHAT’S IN THE BOX
•LED RGB Speaker
•Remote Control
•Charging Cable
•Tripod with LED lights
•Wired Microphone
•User Manual

Speakers: 6.5 inch x 2
Play time: Up to 3 hours
(50% volume)
Input: DC 5V 1A
Charging Time: Approximately 4
-6 hours
Input: DC 5V 1A
Battery Runtime: Up to 3 hours
Charging Time: Approximately
2.5 hours
SPECIFICATIONS
SPEAKER:
TRIPOD:

TIPS FOR SAFE CHARGING
1. Avoid overcharging. Disconnect chargers and
devices after the battery reaches a full charge.
Leaving devices on a charger too long can cause
them to overheat and can reduce battery life.
2. Pick the right charger. Only use the
charger and cable that came with your device.
If no charger was supplied or using your own
charger, always follow the manufacturer’s
recommend charger requirements. Take special
care to match the correct voltage and amp
values your device requires when picking a
charger. Chargers are designed for specic
battery types; mixing chargers and batteries
could result in unexpected problems.
3. Charge only on non-ammable surfaces.
Devices and chargers can get warm or sometimes
even hot during charging. Make sure to always
place the device and charger on a non-ammable
surface when charging. Do not place on beds,
pillows, paper, or near any fabric such as curtains
or clothing under any circumstances.

TIPS FOR SAFE CHARGING
4. Avoid extreme environments. Do not recharge
your devices in environments where extreme
temperatures can occur. On particularly hot days
do not charge in places such as the inside of a
car, or an unairconditioned room. If it’s possible,
try and wait till the evening when temperatures are
a bit cooler.
5. Monitor charging. Recharge your devices
while you are nearby, preferably in the same room
or another room close by. This way when there is
a defective battery or charger, you can take it o
the power supply immediately.
continued...

PRODUCT DIAGRAM
CONTROL PANEL:
9. Mic In
10. Prev/Rec
11. Next/Microphone Priority
12. Repeat/VOL-
13. Power/ Master Volume
Control Dial (-/+)
14. Pause/Play/
True Wireless Stereo
1. LED Mode
2. Mode/ VOL+
(AUX, Bluetooth”, FM Radio)
3. Input (5V)
4. Charger LED
5. LED SW (Lights On/O)
6. Micro SD Card
7. USB
8. AUX In
(Record feature n/a)

continued...
PRODUCT DIAGRAM
Do not adjust
more than 30cm
in height for
safety
Safety pin must
be inserted after
extension
Tighten knob to
secure extension
pole
Tighten knob to
secure lower
extension pole

TRIPOD ASSEMBLY
• Loosen knob unfold all three legs from the
tripod and place on a level surface. Then tighten
the knob to secure the tripod base after
adjusting to your desired height.
• Insert extension pole into lower pole. Do not
extend pole more than 30cm.
• Adjust your desired height within 30cm range,
insert safety pin into extension pole & tighten
knob on extension pole.
• There is a hole in the bottom of the speaker.
Carefully insert the bottom of the speaker onto
extension pole.
Warning:
Speaker sits on tripod only. They are not securely
attached. To move speaker & tripod, you must carry
them separately

TRIPOD CONTROLS
CHARGING THE TRIPOD
AND SPEAKER
1. Press the ON/OFF button to turn on or turn
o the LEDs.
2. Press the lighting mode button to switch the
LED mode.
• USB-C to USB-A charging cable included
• A 1A wall charger (not included) with a USB-A
port is required for charging.
• Plug USB-C end of charging cable into the
USB-C charging port on top section of speaker
to charge speaker.
• Plug USB-C end of charging cable to bottom
section of tripod to charge tripod.
• The Indicator Light stays red when charging.

Put 2 x AAA batteries (not included) into the remote
control.
Point the remote directly from the front of the
speaker for proper use.
REMOTE CONTROL
ON/OFF
Press to stop playing music,
then press play to return to
the rst song.
Switch mode: BT/
AUX FM/USB/
Micro SD Card
Silent Mode
Play/Pause
Next track/channel
Sound eects choices:
POP, CLASSIC, ROCK,
JAZZ, NORMAL
Volume up
Previous song/
channel
Volume down
Repeat
Select track number
on USB or
Micro SD Card

OPERATING INSTRUCTIONS
PAIRING:
• Turn the Speaker on
• The Speaker will automatically enter pairing
mode
• Open the Bluetooth settings on your device,
then search for and select “SPK-LED690BLK”
AUX MODE:
• Plug your 3.5mm audio cable (not included)
into the 3.5mm socket located at the top of the
speaker
FM MODE:
• Press the mode button to switch to FM mode
• Press Play/Pause to auto-search channels in
FM mode
• Using the Next/Previous song functions will
change stations

SD CARD MODE:
• Insert a micro SD card into the SD card slot
• The Speaker will automatically enter SD Card
mode and start playing the les
• Maximum micro SD card size is 32GB
OPERATING INSTRUCTIONS
USB MODE:
• Insert a USB drive into the USB Port
• The Speaker will automatically start playing the
les
• Maximum USB drive size is 32GB
MICROPHONE INPUT:
• Plug the 6.5mm end of the Microphone cable
into the MIC socket on the Speaker and the other
end into the Microphone
• Slide the power button on the microphone to
turn it on
continued...

OPERATING INSTRUCTIONS
LED MODE:
• Press the LED SW button to turn on the
Speakers lights
• Press again to turn them o
• Short press LED MODE to change the LED
mode
continued...
REPEAT MODE:
• Short press the Repeat button to repeat the
current track in USB or SD Card mode
• Press again to repeat all tracks on the USB or
SD Card

OPERATING INSTRUCTIONS
TWS MODE:
• Turn on two identical speakers into their
Bluetooth pairing modes.
• Press and hold the TWS button on both
speakers. A tone will be heard when successfully
paired.
• Search for and select “SPK-LED690BLK”
under the Bluetooth settings of a device you are
connecting to e.g., smartphone.
• Once paired, any music played will come out
of both speakers in separated stereo channel
(dependent on source material).
• Press and hold the TWS button to turn o TWS
mode.
TIP: TWS pairing will not work if either of the
speakers are already connected to a device via
Bluetooth. Please disconnect the speakers from
Bluetooth rst.
continued...

TROUBLESHOOTING
NO POWER:
• A 5V/1A USB wall adapter is required for
charging the speaker and the tripod.
• Check battery level and charge if required.
• Try turning on speaker or tripod while
connected to a power source.
PROBLEMS CONNECTING TO
BLUETOOTH:
• Place the Speaker next to the smart device
you are pairing to e.g., Smartphone.
• If the Bluetooth name “SPK-LED690BLK” does
not appear on the list of available devices, then
try refreshing the list or searching again.
• Allow up to 1 minute for the device to appear
on the Bluetooth list.
• Make sure the Speaker is in Bluetooth mode
(default mode when turning on speaker) before
searching on your smart device.

Thank you
for your purchase!
Laser Corporation is 100% Australian owned
& operated. To get the most out of your
product please read the user manual
carefully and keep for future use.
For specic information relating to your product
such as Spare Parts, FAQs, Warranty claims, and
more, please scan the following QR code:

for your purchase!
Visit our website
www.laserco.com.au
Check us out at
www.youtube.com/lasercoau