Lassco Wizer LasscoJog LJ-2 User manual

Lassco Wizer
LasscoJog LJ-2 Table
Top Paper Jogger
Instruction Manual

Before operating this equipment, please read these
instructions completely and keep these operating
instructions for future reference.
Serial Number:
Date of Purchase:
Dealer:
Address:
Telephone Number:
LasscoJog LJ-2 Paper Jogger
485 Hague Street, Rochester, NY 14606 U.S.A.
Tel: [phone] Fax: [phone]
www.lasscowizer.com [e-mail]

Instructions
Page 01
Your LJ-2 LasscoJog Paper Jogger comes ready to use. Simply plug in the power cord
and turn on the machine.
Note:
Setting Up Your Machine
To change the Jogging action, access the adjustment discs on the underside of the machine as
shown. Loosen Button Head Machine Screw and rotate one of the Adjustment Discs
attached to the Disc Shaft extending from the Motor . Tighten down the Machine Screw.
Adjusting the Jogging Speed
When the screws are located opposite each other on the shaft, the minimum action is
obtained. When the screws are located on the same side of the shaft, the maximum
action is obtained. Normal action is obtained when the screws are 80 to 90 apart.
Underside View
Side View
L-1014: Motor
FM5-5008: Electric Cord
L-1020: #6 Hose Clamp
L-1019: Torque Tube
L-1021: Shaft Collar
L-1017: Eccentric Adjustment Disc
10-32 Screw x 3/4 Button Head Machine Screw
L-1018: Eccentric Disc Shaft
3/8” ID x 3/4” OD Fiber Washer
L-1016: Clevis
L-1034: Flange Bearing

Page 02
Trouble Shooting Guide
Problem Cause Correction
Machine does not turn on. Machine is not plugged in or
there is no electricity to the outlet.
Make sure the power cord is
connected correctly and that the
outlet is live.
Power switch is faulty. Contact a service technician to
replace the power switch.
The motor turns on but the
machine does not jog as
desired.
The Torque Tube (L-1019) has
worn out or broken.
Replace the Torque Tube.
The screw on the Eccentric
Adjustment Disc (L-1017) has
come loose allowing the disc to
shift.
Access the Adjustment Discs and
tighten down the screw as shown
on page 1.
Motor has burned out. Contact a service technician to
replace the motor.