latch LEVER SET User manual

LEVER SET
INSTALLATION GUIDE
INSTALLATION GUIDE

Inside the Box.

Hardware.
X4 X1 X2 X2 X2
PREPARATION
For doors
with 1 - 3/4"
thickness.
For doors
with 1 - 3/8"
thickness.

A
B
Measure.
Select the correct cutsheet according to the door thickness.
Identify if your door has backset A or backset B with the
cutsheet. Reuse the cutsheet you used for installing Latch
C Series.
X2
A
B
1-3/8"1- 3 /4"
Thicker Doors. Thinner Doors.

Extend or retract the latchbolt depending on the
backset type.
A
B
A
B
INSTALLATION
A) Extend
B) Retract

Insert the bracket from the outside of the door all
the way in.
2
X1
Insert the latchbolt depending on the swing of your door.
X1
1
Important
Your door might look different from the installation example used
throughout the guide due to handing and swing direction.

4Assemble the spindle set using a screwdriver.
X1X1X1
Screw the latchbolt in.
3
X2
Important
Make sure that all screws are installed
from the interior to prevent tampering.

5Insert the two levers.
X2
6Screw the levers together tightly.
X2X2
Choose the post set depending on your door’s thickness.
or
Thicker Doors. Thinner Doors.
Make sure to align the
posts and screws inside
of the door.
Important
Make sure that all screws are installed
from the interior to prevent tampering.
(1 - 3/4”) (1 - 3/8”)

7Place the covers by pressing rmly against the door.
X2
Slot should point
towards the ground.

Visit support.latch.com if you have any questions during install.
We are here for you.