latch M Series User manual

INSTALLATION GUIDE
MSERIES

Inside the Box

STRIKE PLATE STRIKE BOX

Hardware
X2 X1X1 X1 X1

X4 X2 X2 X2X2 X2

HANDING
+HUH·VKRZWRPDNHFKDQJHVWRWKHÀHOGUHYHUVLEOHPRUWLVH
FDUWULGJHEDVHGRQ\RXUGRRUKDQGLQJDQGVZLQJ

How to change the latch-bolt position:
1Remove the set screw with the Allen wrench.

2Pull the latch-bolt out of the lock.

3Rotate the latch-bolt 180° and reinstall into the lock.
Push the latch-bolt into the lock and then release.

4Reinstall the set screw and tighten securely with the
Allen wrench.
INSERT THE SET SCREW
FROM THE OPPOSITE SIDE

How to change the locking slide position:
1Remove the two screws as shown below.

2Reinstall the screws on the opposite side of the
mortise cartridge.
THE SCREWS SHOULD BE ON THE INTERIOR SIDE OF THE DOOR.

PERMANENT POWER WIRING
2SWLRQDOSUHSDUDWLRQIRUSHUPDQHQWO\SRZHULQJWKHGHYLFH

1Remove cap from mortise power cable.

2Connect power wires (12-24VDC) to mortise power cable
with dolphin connectors.

INSTALLATION

1
1.1
Prepare the door according to the template provided.
Install the mortise cartridge as shown and secure with
two screws. Feed the cable through as shown.
Avoid pinching or pulling on the cable.
CABLE ROUTING
Shown for left-handed door.
For right-handed doors,
the mortise cable is fed
through the hole furthest
from the door edge.
X2
Place the thumb-turn spindle to
help balance the inner mounting
plate while assembling the
handle in the next step.
X1