LCUT Creative B 70-17 User manual

LCC Modelling System
General retaining wall assembly instructions
All drawings are not in scale.
LCC Modelling System is flexible and you can make easy modifica-
tion. Please visit our website at www.lcut.co.uk to shop for additional
LCC elements.
! We recommend PVA or any other paper/wood glue.
B 70-17 contains:
 1x LCC 70-94
 1x LCC 70-95
 1x LCC 70-96
 1x LCC 70-98
 2x LCC 70-99
B 70-17 T-pack contains:
 3x LCC 70-94
 3x LCC 70-95
 3x LCC 70-96
 3x LCC 70-98
 6x LCC 70-99
Before assembly of individual units it is recommended to glue all
of the face panels (LCC 70-94) together first. If working on long
stretch of retaining wall glue 3-4 panel faces together to make it
easier to assemble later. It is possible to assemble all units
separately and then later join them but this approach may create
gaps between units.
To glue panel faces together apply glue in between the
interlocking bricks and the press gently together. Leave
overnight to dry if possible. This will ensure minimal gaps
between panels. After glue had time to dry follow the instructions
in this manual to assemble the units.
Painting recommendation:
We recommend using acrylic paints. There is no need to under-
coat the surface but it can be done if desired. The material used
is porous and relatively forgiving, heavy coats are unlikely to
flood the brickwork.
!
Last step is to assemble to
parapet and road. Glue LCC
70-95 to each other as shown
on the diagram. Then glue the
blank piece to the top of the
main assembly. Finish off with
gluing the parapet to the road
panel.

Start by cutting out the long
strip from LCC 70-98l and
LCC 70-98r. Proceed to glue
the strip in marked location
flush with the engraved line.
Glue one of the LCC 70-98
infills to the back panel. Using
the strip from previous step as
a reference glue the back
panel perpendicular to the in-
fill panels. The panel should
be position into the gap be-
tween the strip and the brick-
work.
Glue two of the support
brackets to the back of the
back panel. Ideal locations for
the brackets are flush with the
bottom of the model and then
at the level which the strips
on LCC 70-98 end.
To complete the infill glue the
remaining LCC 70-98 to the
other side of the assembly.
Finally finish the base as-
sembly by gluing the face
panel to the back assembly.
The material used to make
this model is flexible and will
bend easily to the shape of
the back assembly. Do not
use excessive force and let
the front panel follow the cur-
vature of LCC 70-98l and
LCC 70-98r.