kingsley-bate Tropez ST70 User manual

Kingsley-Bate
ST70 Tropez Chaise Lounge
Assembly Instructions

KINGSLEY–BATE
Fine Garden Furniture
0ASSEMBLY INSTRUCTIONS FOR THE ST-70
1*NOTE
A TENON
B MORTISE
HOLE
2 WHEEL ASSEMBLY FRONT LEG
3STEP-I
Unpack, inspect and lay the parts on a clean, flat, s oft surface to avoid
marring the wood.
NOTE: During assembly of the furnitu re please match the jo ints with
the corresponding letters or numbers stamped on the furniture.
6CHAISE FRAME
STEP-II
With a rubber mallet, gently knock FRONT
LEG and the WHEEL ASSEMBLY leg into
their corresponding places. Please be s ure
to match the numbere d tenons w ith the
corresponding mortise holes.
4STEP-III
Insert the locking dowels and drive them in
gently. If you use a hammer be sure to
place the sanding block provided
between the hammer and the leg for the
last few blows. This will prevent marring of the wood. Do not force do wels. If dowels
are not completely flush just sand away any excess with the sanding block.

5STEP-IV
Insert the bolts through the wheels and slid e the bigger washers onto each bolt. Now,
insert the bolts t hrough the WHEEL ASSEMB LY legs and slide t he second smaller
washers onto the bolts. Tighten the nut with the tool provided. Do not tighten too hard, or
the wheels will not turn.
IF YOU HAVE ANY QUES TIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE
DEALER NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU
FOR CHOOSING OUR FURNITURE.
*KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY.
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]