Leenders DAYNA User manual

DAYNA
INSTALLATION EN

DAYNA LEENDERS
201742.002.I.EN
Points of aenon installaon Dayna
Transport
Take the Dayna on a hand truck from the
le side.
To level
Use the 4 adjustable feet.
Remove transport guard
Only remove the transit guard aer the Dayna
has been connected to the chimney.
Remove 3 x m8 Allen screw + lock nut.

DAYNA LEENDERS
201742.002.I.EN
A
Bovenaanzicht voet Dayna
Mount the cover for the rest.
Check that the air regulator valve can move
freely and does not touch the foot edge. In case
the cover does not connect correctly at the top
edge (= too ght), the 4x adjustable feet need to
be levelled.
2 x 30 degrees rotaon (rear connecon)
2 x m8 Allen screw + lock nut at posion A.
B
2 x 60 degrees rotaon
Place 1 x m8 Allen screw + lock nut at posion
B without allowing it to touch the base of the
stove.
A
Check interior
Parts in the interior and combuson chamber can shi during transport. Remove the heat
shield. Check if the venlaon pipe above the stove is seated properly = slide securely into
posion underneath. Check if the two vercal venlaon pipes between the stones are
properly seated underneath. Replace the heat shield.

DAYNA LEENDERS
201742.002.I.EN
General instrucons and regulaons
Installaon
To secure the warranty, the Dayna must be installed by a properly qualied person employed by a
dealer recognized by Leenders. See leenders.nl for a current list of addresses of recognized dealers or
contact the manufacturer.
The stove is suscepble to scratching. Handle with care.
Aer installaon, check the draught by burning some kindling wood.
Use
• All local regulaons including those referring to naonal and European standards must be
observed when installing the appliance.
• Ensure there is sucient venlaon/air supply in the room where the stove is installed. Air
extractors such as a cooker hood may cause problems due to ue gases escaping from the stove
into the room.
• The stove is suitable and prepared for connecon to a fresh air supply.
• The stove is suitable for use with a chimney venlator.
• The appliance is not suitable for a shared ue system.
• The appliance must be installed on a oor having sucient bearing capacity.
• Ensure adequate access for cleaning the appliance, the ue-gas connecon and the chimney.
Safety instrucons
• Glass is quite suscepble to breaking and broken glass is quite sharp. Take appropriate measures.
• For general safety, we refer to the VCA guidelines.
• Note: Aer installaon, ensure there is no inammable and/or explosion-hazardous material in or
on the stove such as a spray can, packing material and the like.
Distance to combusble materials
• Back; 20 cm
• Side; 20 cm
• Front; 85 cm
Specicaons Dayna
• Nominal power = 9.9 kWh
• Heat output capacity = 9.9 kWh
• Flue gas mass ow = 9.2 g/s
• Appliance weight = 223 kg
• Minimum chimney draught = 0.12 mbar
• Flue gas temperature directly over the stove = 234 °C
• Energy Eciency 81,1%, class A+, index 108,6
A
+