Leenders Cylon User manual

CYLON
INSTALLATION EN

CYLON LEENDERS
201741.001.I.EN
Points of aenon installaon Cylon
Transport
Place a protecve blanket between the re-
place and the hand truck.
Place the replace on the handtruck with its
backside against the blanket.
Adjustments
Place the M10 hex counterscrews in the 4
sockets.
Level the replace (hex screw nr. 5).
Seng turning angle
120° :remove only the hex counterscrew
(the rearmost).
360°: remove both the screws.
3a
3b
Fastening base cover
Open the air control slide.
Place the nishing cover behind the air
control slide and turn it le to close it.
Then t the back of the nishing cover.
4
Check interior
Parts in the interior and combuson chamber can shi during transport. Remove the heat
shield. Check if the venlaon pipe above the stove is seated properly = slide securely into
posion underneath. Check if the two vercal venlaon pipes between the stones are
properly seated underneath. Replace the heat shield.

CYLON LEENDERS
201741.001.I.EN
General instrucons and regulaons
Installaon
To secure the warranty, the Cylon must be installed by a properly qualied person employed by a
dealer recognized by Leenders. See leenders.nl for a current list of addresses of recognized dealers or
contact the manufacturer.
The stove is suscepble to scratching. Handle with care.
Aer installaon, check the draught by burning some kindling wood.
Use
• All local regulaons including those referring to naonal and European standards must be
observed when installing the appliance.
• Ensure there is sucient venlaon/air supply in the room where the stove is installed. Air
extractors such as a cooker hood may cause problems due to ue gases escaping from the stove
into the room.
• The stove is suitable and prepared for connecon to a fresh air supply.
• The stove is suitable for use with a chimney venlator.
• The appliance is not suitable for a shared ue system.
• The appliance must be installed on a oor having sucient bearing capacity.
• Ensure adequate access for cleaning the appliance, the ue-gas connecon and the chimney.
Safety instrucons
• Glass is quite suscepble to breaking and broken glass is quite sharp. Take appropriate measures.
• For general safety, we refer to the VCA guidelines.
• Note: Aer installaon, ensure there is no inammable and/or explosion-hazardous material in or
on the stove such as a spray can, packing material and the like.
Distance to combusble materials
• Back; 20 cm
• Side; 20 cm
• Front; 85 cm
Specicaons Cylon
• Nominal power = 9.9 kWh
• Heat output capacity = 9.9 kWh
• Flue gas mass ow = 9.2 g/s
• Appliance weight = 140 kg
• Minimum chimney draught = 0.12 mbar
• Flue gas temperature directly over the stove = 237 °C
• Energy Eciency 81,1%, class A+, index 108,6
A
+