Leenders FUGA eL MkII User manual

FUGA eL MkII
INSTALLATION EN
Check interior
Parts in the interior and combuson chamber can shi during transport. Check the heat
shield and all other interior ceramics to make sure everything is in the right place.

FUGA eL LEENDERS
201729.001.I.EN
Points of aenon installaon Fuga eL MkII
Transport
Open the door and li it out of its hinges (see 1).
Posion protecon between the hand truck and
the stove. Put the stove on the hand truck with
the FRONT towards the hand truck (see 2.).
Transit bolts
Rehang the door by slong it back into the hinges
(see 3).
Remove the REAR transit bolt (open ended
spanner SW 13). See 4a.
Adjusng
Loosen the front two bolts slightly (open ended
spanner SW 13) for rotaon of 60º (rear ue)
or 120º (top flue). Remove the two front bolts
through rotating them 360º (only for top flue).
See 4b.
Adjust the stove until it is level about 200mm
from the floor (see 5).
Venlaon
Venlaon: t the cover plate with the M8 bolt
provided (open ended spanner SW 13). See 6.
Position the protective cover underneath; be aware
of the central notch (see 7).
Illustraon of stainless steel fresh
air facility in base and/or back.

FUGA eL LEENDERS
201729.001.I.EN
General instrucons and regulaons
Installaon
To secure the warranty, the Fuga eL MkII must be installed by a properly qualied person employed by
a dealer recognized by Leenders. See leenders.nl for a current list of addresses of recognized dealers
or contact the manufacturer.
The stove is suscepble to scratching. Handle with care.
Aer installaon, check the draught by burning some kindling wood.
Use
• All local regulaons including those referring to naonal and European standards must be
observed when installing the appliance.
• Ensure there is sucient venlaon/air supply in the room where the stove is installed. Air
extractors such as a cooker hood may cause problems due to ue gases escaping from the stove
into the room.
• The stove is suitable and prepared for connecon to a fresh air supply.
• The stove is suitable for use with a chimney venlator.
• The appliance is not suitable for a shared ue system.
• The appliance must be installed on a oor having sucient bearing capacity.
• Ensure adequate access for cleaning the appliance, the ue-gas connecon and the chimney.
Safety instrucons
• Glass is quite suscepble to breaking and broken glass is quite sharp. Take appropriate measures.
• For general safety, we refer to the VCA guidelines.
• Note: Aer installaon, ensure there is no inammable and/or explosion-hazardous material in or
on the stove such as a spray can, packing material and the like.
Distance to combusble materials
• Back; 10 cm
• Side; 10 cm
• Front; 80 cm
Specicaons Fuga eL MkII
• Nominal power = 9.9 kWh
• Heat output capacity = 9.9 kWh
• Flue gas mass ow = 11,3 g/s
• Appliance weight = 180 kg
• Minimum chimney draught = 0.123 mbar
• Flue gas temperature directly over the stove = 239 °C
• Energy Eciency 80,1%, class A+, index 107,1
A
+