Leenders Ysen User manual

YSEN
INSTALLATION EN

YSEN LEENDERS
201736.001.I.EN
Points of aenon installaon Ysen
Dismounng door
Use magnets to place the protecon cardboard
in the upper le corner of the door (see 1a)
Li the door o the hinge pins and remove it
from the mantle (see 1b).
Remove screws
Remove the 4 screws from the top and boom of
the mantle (see 2a + 2b).
Remove mantle
Pry the mantle loose with a plasc re lever (see 3).
Carefully li the mantle and turn it o the hinge
pins in the le corner (see 4).
Transport
Dismantle the Ysen from the pallet with 4 screws
(see 5).
Place the hand truck to the front side of the Ysen
(see 6).
Check interior
Parts in the interior and combuson chamber can shi during transport. Check the heat
shield and all other interior ceramics to make sure everything is in the right place.

YSEN LEENDERS
201736.001.I.EN
Adjustments
Level the Ysen with the adjusng screws in the
corners (see 7).
Mount the mantle: put it on the hinge pins in the
le corner (see 8).
Placing door
Install the four screws in the corner of the mantle
(see 9).
Put the door back into the hinge oins of the
mantle. Use the cartonboard again (see 10).
Check interior
Parts in the interior and combuson chamber can shi during transport. Check the heat
shield and all other interior ceramics to make sure everything is in the right place.

YSEN LEENDERS
201736.001.I.EN
General instrucons and regulaons
Installaon
To secure the warranty, the Ysen must be installed by a properly qualied person employed by a
dealer recognized by Leenders. See leenders.nl for a current list of addresses of recognized dealers or
contact the manufacturer.
The stove is suscepble to scratching. Handle with care.
Aer installaon, check the draught by burning some kindling wood.
Use
• All local regulaons including those referring to naonal and European standards must be
observed when installing the appliance.
• Ensure there is sucient venlaon/air supply in the room where the stove is installed. Air
extractors such as a cooker hood may cause problems due to ue gases escaping from the stove
into the room.
• The stove is suitable and prepared for connecon to a fresh air supply.
• The stove is suitable for use with a chimney venlator.
• The appliance is not suitable for a shared ue system.
• The appliance must be installed on a oor having sucient bearing capacity.
• Ensure adequate access for cleaning the appliance, the ue-gas connecon and the chimney.
Safety instrucons
• Glass is quite suscepble to breaking and broken glass is quite sharp. Take appropriate measures.
• For general safety, we refer to the VCA guidelines.
• Note: Aer installaon, ensure there is no inammable and/or explosion-hazardous material in or
on the stove such as a spray can, packing material and the like.
Distance to combusble materials
• Back; 15 cm
• Side; 40 cm
• Front; 80 cm
Specicaons Ysen
• Nominal power = 9.9 kWh
• Heat output capacity = 9.9 kWh
• Flue gas mass ow = 8.1 g/s
• Appliance weight = 300 kg
• Minimum chimney draught = 0.12 mbar
• Flue gas temperature directly over the stove = 266 °C
• Energy Eciency 81.3%, class A+, index 108,9
A
+