Leenders DIA BASE MkII User manual

DIA BASE MkII
INSTALLATION EN

DIA MkII LEENDERS
201744B.001.I.EN
Points of aenon installaon Dia Base MkII
Transport
• Remove the mantle from the stove by lifting it
carefully.
• Posion protecon between the hand truck
and the stove.
• Put the stove on the hand truck with the
BACK towards the hand truck.
Fixing on oor or support oorplate
• Fix the foot on the special support oorplate
with 4 M8 bolts.
ÓR
• Drill 4 oor anchors into the oor and x the
foot with 4 M8 bolts.
Adjusng
• Fixed: remain all bolts as they are.
• For rotation of 90°: Remove the two rear
bolts and loosen the two front bolts a little
bit ( open ended spanner SW 13 ) and secure
them with the nut.
• For rotation of 360°: Remove all bolts.
Mantle back on the stove
Put the mantle back on the stove by sliding it
down carefully.
Check interior
Parts in the interior and combuson chamber can shi during transport. Check the heat
shield and all other interior ceramics to make sure everything is in the right place.

DIA MkII LEENDERS
201744B.001.I.EN
General instrucons and regulaons
Installaon
To secure the warranty, the Dia Base MkII must be installed by a properly qualied person employed
by a dealer recognized by Leenders. See leenders.nl for a current list of addresses of recognized dea-
lers or contact the manufacturer.
The stove is suscepble to scratching. Handle with care.
Aer installaon, check the draught by burning some kindling wood.
Use
• All local regulaons including those referring to naonal and European standards must be
observed when installing the appliance.
• Ensure there is sucient venlaon/air supply in the room where the stove is installed. Air
extractors such as a cooker hood may cause problems due to ue gases escaping from the stove
into the room.
• The stove is suitable and prepared for connecon to a fresh air supply.
• The stove is suitable for use with a chimney venlator.
• The appliance is not suitable for a shared ue system.
• The appliance must be installed on a oor having sucient bearing capacity.
• Ensure adequate access for cleaning the appliance, the ue-gas connecon and the chimney.
Safety instrucons
• Glass is quite suscepble to breaking and broken glass is quite sharp. Take appropriate measures.
• For general safety, we refer to the VCA guidelines.
• Note: Aer installaon, ensure there is no inammable and/or explosion-hazardous material in or
on the stove such as a spray can, packing material and the like.
Distance to combusble materials
• Back; 25 cm; Temperature during safety test; 81°C
• Side; 25 cm Temperature during safety test; 54°C
• Front; 80 cm Temperature during safety test; 47°C
Specicaons Dia Base MkII
• Nominal power = 7.7 kWh
• Heat output capacity = 7.7 kWh
• Flue gas mass ow = 6,9 g/s
• Appliance weight = 125 kg
• Minimum chimney draught = 0.12 mbar
• Flue gas temperature directly over the stove = 274 °C
• Energie Eciency 80,0%, class A+, index 107,0
A
+