Leenders MATS User manual

MATS
INSTALLATION EN

MATS LEENDERS
201743.001.I.EN
Points of aenon installaon Mats
Top outlet
Install the top outlet.
Place the at strip (included) in
the border on the outlet as well
as on the cover.
Rear outlet
Install the rear outlet.
Place the at strip (included) in
the border on the outlet as well
as on the cover.
Transport
Place the hand truck at the front
of the Mats (see 3).
Before shiing, place an aid
(sliding pieces, strips or carpet
etc.) underneath the Mats.
Finally remove the transport
bracket (see 4 and 5).

MATS LEENDERS
201743.001.I.EN
Check interior
Parts in the interior and combuson chamber can shi during transport. Check the heat
shield and all other interior ceramics to make sure everything is in the right place.
Adjustments
Level the Mats with the four
adjusng crews in the foot
(see 6).

MATS LEENDERS
201743.001.I.EN
General instrucons and regulaons
Installaon
To secure the warranty, the Mats must be installed by a properly qualied person employed by a
dealer recognized by Leenders. See leenders.nl for a current list of addresses of recognized dealers or
contact the manufacturer.
The stove is suscepble to scratching. Handle with care.
Aer installaon, check the draught by burning some kindling wood.
Use
• All local regulaons including those referring to naonal and European standards must be
observed when installing the appliance.
• Ensure there is sucient venlaon/air supply in the room where the stove is installed. Air
extractors such as a cooker hood may cause problems due to ue gases escaping from the stove
into the room.
• The stove is suitable and prepared for connecon to a fresh air supply.
• The stove is suitable for use with a chimney venlator.
• The appliance is not suitable for a shared ue system.
• The appliance must be installed on a oor having sucient bearing capacity.
• Ensure adequate access for cleaning the appliance, the ue-gas connecon and the chimney.
Safety instrucons
• Glass is quite suscepble to breaking and broken glass is quite sharp. Take appropriate measures.
• For general safety, we refer to the VCA guidelines.
• Note: Aer installaon, ensure there is no inammable and/or explosion-hazardous material in or
on the stove such as a spray can, packing material and the like.
Distance to combusble materials
• Back; 25 cm; Temperature during safety test; 65°C
• Side; 30 cm Temperature during safety test; 77°C
• Front; 80 cm Temperature during safety test; 47°C
Specicaons Mats
• Nominal power = 8.0 kWh
• Heat output capacity = 8.0 kWh
• Flue gas mass ow = 6,7 g/s
• Appliance weight = 210 kg
• Minimum chimney draught = 0.123 mbar
• Flue gas temperature directly over the stove = 274 °C
• Energie Eciency 80,4%, class A+, index 107,6
A
+