Leenders DAYNA User manual

SINCE 1979
DAYNA
INSTALLATION EN
DAYNA HARRIE LEENDERS

DAYNA HARRIE LEENDERS
Points of attention installation Dayna
Transport
Take the Dayna on a hand truck from the left side.
To level
Use the 4 adjustable feet.
Remove transport guard
Only remove the transit guard after the Dayna
has been connected to the chimney.
Remove 3 x m8 Allen screw + lock nut.

DAYNA HARRIE LEENDERS
A
Mount the cover for the rest.
2 x 30 degrees rotation (rear connection)
2 x m8 Allen screw + lock nut at position A.
B
2 x 60 degrees rotation
1 x m8 Allen screw + lock nut at position B.
A

DAYNA HARRIE LEENDERS
General instructions and regulations
Installation
•To secure the warranty, the Dayna must be installed by a properly qualied person employed by a
dealer recognized by Harrie Leenders Haardkachels. See leenders.nl for a current list of addresses of
recognized dealers or contact the manufacturer.
•The stove is susceptible to scratching. Handle with care.
•After installation, check the draught by burning some kindling wood.
Use
•All local regulations including those referring to national and European standards must be observed
when installing the appliance.
•Ensure there is sufcient ventilation/air supply in the room where the stove is installed. Air extractors
such as a cooker hood may cause problems due to ue gases escaping from the stove into the room.
•The appliance is not suitable for a shared ue system.
•The appliance must be installed on a oor having sufcient bearing capacity.
•Ensure adequate access for cleaning the appliance, the ue-gas connection and the chimney.
Safety instructions
•Glass is quite susceptible to breaking and broken glass is quite sharp. Take appropriate measures.
•For general safety, we refer to the VCA guidelines.
•Note: After installation, ensure there is no inammable and/or explosion-hazardous material in or on
the stove such as a spray can, packing material and the like.
Distance to combustible materials
• Back; 20 cm
• Side; 20 cm
• Front; 120 cm
Specications Dayna
•Nominal power = 10.1 kWh
•Flue gas mass ow =9.2 g/s
•Appliance weight = 223 kg
•Minimum chimney draught = 0.012 mbar
•Flue gas temperature directly over the stove = 234 °C