Leenders STOR User manual

STOR
INSTALLATION EN

STOR LEENDERS
201734.001.I.EN
Points of aenon installaon Stor
Tranportaon
• Remove the plastic wrapping and save it.
• Open the door, push it upwards, remove it and
put it in a safe place.
• Put plastic wrapping back in place.
• Place styrofoam or a packing cushion between
the stove and the handtruck for protection.
• Move the stove with its front resting against the
handtruck.
Determining the stove’s posion
Determine the centre of the ue on the oor
using a plumb line and mark it o.
Posioning the stove
• Push the stove to the marked posion using
sliding pieces.
Be careful not to damage the oor.
• Remove the sliding pieces.
• Remove the plasc wrapping.

STOR LEENDERS
201734.001.I.EN
Levelling
• Tilt the stove to reach the four adjusng legs.
• Turn the adjusng legs to level the stove.
• Ensure that all four legs touch the oor
evenly so that the stove is rmly posioned
on the oor.
Making the base rotatable
• Fixed posion: leave the base as delivered.
• 2x60° rotatable: release bolt no. 1.
Slightly loosen bolts no. 2, and secure them with
the nut (open-end spanner j.w.13).
• Check to ensure bolts no. 2 have not been
loosened too much.
Installing duct material
• Place the pipe on the turning ring at the top
of the stove.
• Check its operaon.
Check interior
Parts in the interior and combuson chamber can shi during transport. Check the heat
shield and all other interior ceramics to make sure everything is in the right place.
Top view of the base
1
22

STOR LEENDERS
201734.001.I.EN
Placing the door
• Carefully hang the door back on its hinges.
• Be careful not to cause any damage.
Air supplied through the oor
You can cover the holes in the stove with the cover
plate (opon) with the stove.
Check interior
Parts in the interior and combuson chamber can shi during transport. Check the heat
shield and all other interior ceramics to make sure everything is in the right place.
Top view of the base

STOR LEENDERS
201734.001.I.EN
General instrucons and regulaons
Installaon
To secure the warranty, the Stor must be installed by a properly qualied person employed by a
dealer recognized by Leenders. See leenders.nl for a current list of addresses of recognized dealers or
contact the manufacturer.
The stove is suscepble to scratching. Handle with care.
Aer installaon, check the draught by burning some kindling wood.
Use
• All local regulaons including those referring to naonal and European standards must be
observed when installing the appliance.
• Ensure there is sucient venlaon/air supply in the room where the stove is installed. Air
extractors such as a cooker hood may cause problems due to ue gases escaping from the stove
into the room.
• The stove is suitable and prepared for connecon to a fresh air supply.
• The stove is suitable for use with a chimney venlator.
• The appliance is not suitable for a shared ue system.
• The appliance must be installed on a oor having sucient bearing capacity.
• Ensure adequate access for cleaning the appliance, the ue-gas connecon and the chimney.
Safety instrucons
• Glass is quite suscepble to breaking and broken glass is quite sharp. Take appropriate measures.
• For general safety, we refer to the VCA guidelines.
• Note: Aer installaon, ensure there is no inammable and/or explosion-hazardous material in or
on the stove such as a spray can, packing material and the like.
Distance to combusble materials Stor
• Back; 10 cm. Temperature during safety test; 61°C
• Side; 10 cm. Temperature during safety test; 54°C
• Front; 80 cm. Temperature during safety test; 47°C
Specicaons Stor
• Nominal power = 9.9 kWh
• Heat output capacity = 9.9 kWh
• Flue gas mass ow = 11,6 g/s
• Appliance weight = 210 kg
• Minimum chimney draught= 0.123 mbar
• Flue gas temperature directly over the stove = 239 °C
• Energy Eciency 80,1%, class A+, index 107,1
A
+