LEGO Home Alone 21330 User manual

1
21330 Home Alone(classic style)
LED Light Kits
Product List：
Part Name
quantity
4-Port Expansion Boards
1
6-Port Expansion Boards
3
8-Port Expansion Boards
2
15CM Bit Light Green
2
30CM Bit Light Green
2
30CM Bit Light Red
3
15CM Bit Light Warm White
6
30CM Bit Light Warm White
3
30CM Bit Light Blue
1
Connecting Cobles 15CM
3
Connecting Cobles 30CM
4
15CM Enhanced Bit Light Warm White
5
LED Strip Lights Warm
1
LED Strip Lights Warm White
3
Battery box AA (USB port)
1
USB Connecting Cables
1
Parts Package
1

2
Precautions:
Route wires above and below the baseplate
The wires can be placed between the building block and the board or under the
block, but they should be placed between the studs correctly
Install dot lights on the building blocks
Please make sure they are placed correctly (yellow LED components are
exposed). You can place them directly on top of the block stud or between the
two.
Link the connecting cables to expansion boards

3
Connect the connecting cables to the strip lights
Put the battery into the battery box
Several battery boxes have different specifications, please pay attention to
the positive and negative poles of the battery.

4
Installation Notes
Take out the button cell box and insert 2 CR2032 coin cells correctly（Sorry,
because the battery is dangerous, we can’t provide it, you need to buy it
at a convenience store）
Take out the button cell box and 8-Port Expansion Boards

5
Take : 1pcs-15cm dot lights warm white
After the test, turn off the power, pull out the dot lamp,leave the 8-port
expansion boards on the power supply
If you want to keep the light on, you can turn on the USB power supply

6
Begin
Separate the upper and lower floors of the building

7
Remove the ground string lights, and remove the parts shown by the arrow

8
Remove the parts indicated by the arrow one by one

9
Here can be operated with the aid of the starter

10