LevelOne FCS-3071 User manual

FCS-3071
2-Megapixel PoE Dome Network Camera
User Manual
Ver 1.0
HW Ver: 2.0

1
Table of Contents
1. Overview ........................................................................................................................................3
1.1 Features..............................................................................................................................4
1.2 Package Contents ...............................................................................................................4
1.3 Dimensions.........................................................................................................................5
1.4 Connectors .........................................................................................................................6
2. System Requirements ....................................................................................................................7
3. Accessing Camera...........................................................................................................................8
3.1 Recording Software..........................................................................................................12
3.2 Installing DC Viewer Software Online ..............................................................................13
4. Operation & Configuration...........................................................................................................15
4.1 Browser-based Viewer Introduction................................................................................15
4.2 Home Page .......................................................................................................................17
4.2.1 Function Items on Home Page.............................................................................17
4.3 System..............................................................................................................................19
4.3.1 System..................................................................................................................19
4.3.2 Security ................................................................................................................21
4.3.2.1 User ......................................................................................................................21
4.3.2.2 HTTPS ...................................................................................................................23
4.3.2.3 IP Filter.................................................................................................................26
4.3.2.4 IEEE 802.1X...........................................................................................................27
4.3.3 Network ...............................................................................................................29
4.3.3.1 Basic .....................................................................................................................29
4.3.3.2 QoS.......................................................................................................................32
4.3.3.3 SNMP....................................................................................................................33
4.3.3.4 UPnP.....................................................................................................................35
4.3.3.5 DDNS ....................................................................................................................37
4.3.3.6 Mail ......................................................................................................................39
4.3.3.7 FTP........................................................................................................................40
4.3.3.8 HTTP .....................................................................................................................41
4.3.3.9 Motion Detection.................................................................................................42
4.3.3.10 Network Failure Detection.................................................................................48
4.3.3.11 Tampering ..........................................................................................................50
4.3.3.12 Storage Management (Local Recording)............................................................54
4.3.3.13 Recording (Local Recording) .............................................................................56
4.3.3.14 File Location (Snapshots and Web Recording) ..................................................57
4.3.3.15 View Information ...............................................................................................58

2
5.3.3.15.1 Log File.............................................................................................................58
4.3.3.15.2 User Information..............................................................................................59
4.3.3.15.3 Parameters.......................................................................................................60
4.3.3.16 Factory Default...................................................................................................61
4.3.3.17 Software Version................................................................................................62
4.3.3.18 Software Upgrade ..............................................................................................63
4.3.3.19 Maintenance ......................................................................................................65
4.4 Streaming .........................................................................................................................66
4.4.1 Video Format (Video Resolution and Rotate Type) .............................................66
4.4.2 Video Compression..............................................................................................68
4.4.3 Video ROI .............................................................................................................70
4.4.4 Video OCX Protocol..............................................................................................72
4.4.5 Video Frame Rate ................................................................................................73
4.4.6 Video Mask ..........................................................................................................74
4.5 Camera .............................................................................................................................76
4.5.1 Exposure Setting ..................................................................................................77
4.5.2 White Balance Setting..........................................................................................78
4.5.3 Picture Adjustment ..............................................................................................79
4.3.4 Backlight...............................................................................................................80
4.3.5 Digital Zoom .........................................................................................................80
4.3.6 WDR Function ......................................................................................................80
4.3.7 Noise Reduction ...................................................................................................80
4.3.8 TV System Setting.................................................................................................81
4.4 Logout ..............................................................................................................................81
Appendix A: Internet Security Settings ................................................................................................82
Appendix B: DC Viewer Download Procedure .....................................................................................85
Appendix C: Install UPnP Components ................................................................................................87
Default ID / Password
Login ID
Password
root

3
1. Overview
The LevelOne FCS-3071 is a compact, rugged H.264 2-Megapixel PoE Mini Dome Camera
designed for tough environments. The casing is tamper-resistant, it can withstand vibration,
humidity, dust and fluctuating temperatures, for example in buses and trains.
The FCS-3071 is a palm-sized, discreet network camera specifically designed for mass
transit vehicles. The flat tamper-resistant casing makes it ideal for installation.
The IP66 rating provides a rugged package for both indoor and outdoor applications. In
compatible with EN50155, the standard for electronic equipment operating in railway
vehicles, the FCS-3071 is an economical mobile surveillance solution with high reliability
and rugged performance.
The FCS-3071 utilizes PoE (Power-over-Ethernet), allowing it to be operated and powered
from a single Ethernet cable, giving greater ease of installation and cost savings. In order to
facilitate onboard storage and data portability, the FCS-3071 is also complete with a Micro
SD/SDHC card slot for local recording.

4
1.1 Features
Progressive Scan CMOS Sensor
H.264 and MJPEG compression
Motion Detection
Privacy Masks
WDR
Smart Picture Quality/3DNR
Tampering Alarm
Day/Night (ICR)
Micro SD support
Weatherproof (IP66 international)
Micro SD support
Security Torx against tampering
ONVIF Support
1.2 Package Contents
FCS-3071
Security TorxM4 Inner Hex Wrench
Screw Set
Quick Installation Guide
CD Manual / Utility

5
1.3 Dimensions

6
1.4 Connectors
The diagram below shows the IP Camera’s reset button and various connectors. Definition
for each connector will be given as follows.
Designation Description
1
Reset Button
Restore to default setting; press the button with a proper tool
2
Lens
Rotate the lens right/left to adjust focus
3
Focus Fixed Screw
Loosen the screw to adjust the lens
4
Tilt Fixed Screw
Loosen the screw to adjust tilt angle
5
Micro SD Card Slot
Micro SD Card recording.

7
2. System Requirements
To perform the IP Camera via web browser, please ensure your PC is in good network
connection, and meet system requirements as described below.
Items
System Requirement
Personal Computer
1. Intel® Pentium® M, 2.16 GHz or
Intel® CoreTM2 Duo, 2.0 GHz
2. 2 GB RAM or more
Operating System
Windows VISTA/ Windows XP/ Windows 7
Web Browser
Microsoft Internet Explorer 6.0 or later
Firefox
Chrome
Safari
Network Card
10Base-T (10 Mbps) or 100Base-TX (100 Mbps) operation
Viewer
ActiveX control plug-in for Microsoft IE

8
3. Accessing Camera
For initial access to the IP Camera, users can search the camera through the installer
program: DeviceSearch.exe, which can be found in “DeviceSearch” folder in the supplied
CD.
Device Search Software
Step 1:
Double click on the program Device Search.exe (see the icon below); its window will appear
as shown below. Then click the “Device Search” button.
Step 2:
The security alert window will pop up. Click “Unblock” to continue.

9
Step 3:
Click “Device Search” again, and all the finding IP devices will be listed in the page, as
shown in the figure below. The IP Camera’s default IP address is: 192.168.0.250.
Step 4:
Double click or right click and select “Browse” to access the camera directly via web
browser.
Step 5:
Then the prompt window of request for entering default username and password (as
shown below) will appear for login to the IP Camera.

10
The default login ID and password for the Administrator are:
Login ID
Password
root
NOTE: ID and password are case sensitive.
NOTE: It is strongly advised that administrator’s password be altered for the
security concerns.
Additionally, users can change the IP Camera’s network property, either DHCP or Static IP
directly in the device finding list. Refer to the following section for changing the IP Camera’s
network property.
Example of Changing IP Camera’s Network Property
Users can directly change an IP Camera’s network property, ex. from static IP to DHCP, in
the finding device list. The way to change the IP Camera’s network property is specified
below:
Step 1:
In the finding device list, click on the IP Camera that you would like to change its network
property. On the selected item, right click and select “Network Setup.” Meanwhile, record the
IP Camera’s MAC address, for future identification.
Step 2:
The “Network Setup” page will come out. Select “DHCP,” and press “Apply” button down the
page.

11
Step 3:
Click “OK” on the Note of setting change. Wait for one minute to re-search the IP Camera.
Step 4:
Click the “Device Search” button to re-search all the devices. Then select the IP Camera
with the correct MAC address. Double click on the IP Camera, and the login window will
appear.
Step 5:
Enter User name and Password to access the IP Camera.

12
3.1 Recording Software
The product software CD also contains recording software- IP CamSecure, allowing
simultaneous monitoring and video recording for multiple network cameras. Please install
the recording software; then launch the program to add the Network Camera to the Channel
list. For detailed information about how to use IP CamSecure, please refer to the user’s
manual of the software or download it at http://global.level1.com.

13
3.2 Installing DC Viewer Software Online
For the initial access to the IP Camera, a client program, DC Viewer, will be automatically
installed to your PC when connecting to the IP Camera.
If the Web browser doesn’t allow DC Viewer installation, please check the Internet security
settings or ActiveX controls and plug-ins settings (see Appendix A: Internet Security Settings)
to continue the process.
The Information Bar (just below the URL bar) may come out and ask for permission to install
the ActiveX Control for displaying video in browser (see the figure below). Right click on the
Information Bar and select “Install ActiveX Control…” to allow the installation.
Then the security warning window will pop up. Click “Install” to carry on software installation.
Click “Finish” to close the DC Viewer window when download is finished. For the detailed
software download procedure, please refer to Appendix B: DC Viewer Download Procedure.

14
Once login to the IP Camera, users will see the Home page as shown below:

15
4. Operation & Configuration
The IP Camera is provided with a user-friendly browser-based configuration interface for
video playback and recording. In this chapter, information about main page introduction,
system related settings and camera settings will be described in detail.
4.1 Browser-based Viewer Introduction
There are five main tabs including <Home>, <System>, <Streaming>, <Camera> and
<Logout> on the Home Page.
Home
Users can monitor live video of the targeted area.

16
System setting
The administrator can set host name, system time, root password, network related settings,
etc. Further details will be interpreted in chapter System.
Streaming setting
The administrator can modify video resolution and rotate type and select audio compression
mode in this page.
Camera setting
Users can adjust various camera parameters, including <Exposure>, <White Balance>,
<Picture Adjustment>, <Backlight>, <Digital Zoom>, <WDR Function>, <Noise Reduction>
and <TV System>.
Logout
Click on the tab to re-login the IP Camera with another username and password.

17
4.2 Home Page
Click on the tab <Home> to access the Home Page. There are several function buttons on
the Home page. Detailed information of each item is as described in the following chapter.
4.2.1 Function Items on Home Page
Multiple Languages Support
Multiple languages are supported, including German, English, French, Italian, Simplified
Chinese, Traditional Chinese, Russian for the viewer window interface.
Digital Zoom Control
In the full screen mode, users can implement digital PTZ by rotating the mouse wheel (for
zoom in/ out), and drag the mouse into any direction.

18
Screen Size Adjustment
Image display size can be adjusted to x1/2 and full screen.
Snapshot button
Click on the button and the JPEG snapshots will automatically be saved in the appointed
place. The default place of saving snapshots is: C:\. To change the storage location, please
refer to File Location for further details.
NOTE: For users with Windows 7 operating system, it is required to log on as an
Administrator to implement the Snapshot function.
Video Streaming Pause /Restart button (pause/restart)
Click on the <stop> button to disable video streaming, the live video will be displayed as
black. Click on the <restart> button to show the live video again.
Web Recording button (on/off)
Click on the <Recording> button and the Live View through the web browsing will be directly
recorded to the specific location on the local hard drive, which could be configured in the
<File Location> page. The default storage location for the web recording is: C:\. Please refer
to File Location for further details.
NOTE: For users with Windows 7 operating system, it is required to log on as an
Administrator to implement the Web Recording function.

19
4.3 System
Under the tab <System>, there are submenus including: <System>, <Security>, <Network>,
<DDNS>, <Mail>, <FTP>, <HTTP>, <Application>, <Motion Detection>, <Network Failure
Detection>, <Tampering>, <Storage Management>, <Recording>, <File Location>, <View
Information>, <Factory Default>, <Software Version>, <Software Upgrade>, and
<Maintenance>.
NOTE: The System configuration page is only accessible by the Administrator.
4.3.1 System
The System Setting can be found under the path: System> System.