Lexmark E360D series User manual

Quick Reference
Loading paper
1 Pull the tray completely out.
2 Squeeze the width guide tabs on the right guide as shown, and
slide the width guides to the sides of the tray.
3 Squeeze the length guide tabs together as shown, and slide
the length guide to the correct position for the paper sizebeing
loaded.
4 Flex the sheets back and forth to loosen them, and then fan
them. Do not fold or crease the paper. Straighten the edges on
a level surface.
5 Load the paper stack toward the back of thetray as shown with
the recommended print side facedown.
Note: Notice the maximum fill line on the side of the width
guide which indicates the maximum height for loading paper.
Do not try to overload the tray.
1Maximum fill line
When loading letterhead, place the top edge of the sheet
toward the front of the tray. Load the letterhead with the
design placed facedown.
6 Squeeze the width guide tabs on the right guide, and slide the
width guides to lightly touch the side of the stack.
7 Insert the tray.
Loading paper
1

Clearing paper jams
If a jammed sheet is visible, then pull it out gently. If the jam is not
visible, then complete the following steps:
Clearing jams behind the
photoconductor kit and toner
cartridge unit
1 Open the front door, and then remove the photoconductor kit
and toner cartridge unit.
CAUTION—HOT SURFACE: The inside of the printer
might be hot. To reduce the risk of injury from a hot
component, allow the surface to cool before touching.
2 Lift the flap at the front of the printer, and then remove any
jammed sheets of paper.
Clearing jams under Tray 1
1 Remove the tray from the printer.
2 Locate the lever shown. Pull the level down to release the jam.
3 Pull the jammed sheets from the duplex area.
Clearing jams behind the rear door
1 Open the front door, and then open the rear door.
2 Remove the jam.
After clearing the paper jam
1 Align and insert the unit.
2 Insert the tray.
3 Close the doors.
4 Press .
Loading paper
2