Lexmark X203N series Instruction and safety manual

Quick Reference

Contents
Loading paper and specialty media...............................................3
Loading the paper tray........................................................................................................................................................3
Clearing jams.......................................................................................7
200–201 paper jam................................................................................................................................................................7
202 paper jam.......................................................................................................................................................................10
241 paper jam.......................................................................................................................................................................13
251 paper jam.......................................................................................................................................................................14
Contents
2

Loading paper and specialty media
Loading the paper tray
Do not load the paper tray while a job prints or while Busy appears on the display. Doing so may cause a paper jam.
1Pull the paper tray completely out.
2Squeeze the width guide tabs on the right guide as shown, and slide the width guides to the sides of the tray.
The width guides move in unison.
Loading paper and specialty media
3

3Squeeze the length guide tabs together as shown, and then slide the length guide to the correct position for the
paper size. Use the size indicators on the bottom of the tray to help position the guide.
If you are loading a longer size of paper, then squeeze the length guide tab and slide the length guide backward
to the correct position for the paper size. The tray extends backward as shown.
4Flex the sheets back and forth to loosen them, and then fan them. Do not fold or crease the paper. Straighten the
edges on a level surface.
Loading paper and specialty media
4

5Load the paper stack toward the back of the tray as shown with the recommended print side facedown.
Note: The maximum fill line on the side of the width guide indicates the maximum height for loading paper. Do
not overload the tray.
Load letterhead with the print side facedown and the top edge of the sheet toward the front of the tray.
6Squeeze the width guide tabs on the right guide, and then slide the width guides to lightly touch the side of the
stack.
Loading paper and specialty media
5

7Insert the paper tray.
8If the paper type you loaded differs from the type that was previously loaded in the tray, then change the Paper
Type setting for the tray.
Loading paper and specialty media
6

Clearing jams
200–201 paper jam
200 paper jam
1Remove the tray from the printer.
Clearing jams
7

2Remove the jam if you see it here.
3If you do not see it, see “201 paper jam” on page 8.
201 paper jam
1Open the front door, and then remove the photoconductor kit and toner cartridge.
Clearing jams
8

2Lift the flap at the front of the printer, and remove any jammed sheets.
3Align and insert the photoconductor kit and toner cartridge.
4Close the front door.
5Insert the tray.
6Press .
Clearing jams
9

202 paper jam
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a hot
component, allow the surface to cool before touching.
1Open the front door, and then remove the photoconductor kit and toner cartridge.
Clearing jams
10