Liberty Garden 704 User manual

How to reverse the crank handle for the model 704/705
Tools Needed: Allen wrench,
hex screw driver or flat head
screw driver and channel locks
or vice grips.
Step 1: Loosen black plastic locking ring on shaft of swivel. Loosen hex nut on left side (located on the inside of
the reel). **DO NOT REMOVE HEX SCREW** This is very difficult to reattach. The shaft of the swivel will
have to be unscrewed from elbow. Hold the elbow when unscrewing swivel shaft and remove swivel from the left
side of reel. If you are not able to hold the shaft effectively to unscrew from reel’s elbow (located on the inside of
the reel) you will have to remove the brass square head of swivel.
**Removing brass square to swivel: Remove “C” clip from end of square brass swivel (located on the left side of
the reel). This will allow you to hold the shaft effectively when you unscrew the reel.
Step 2: Remove swivel from reel.
Swivel
Elbow Crank handle
Hex nut Hold the elbow stationary to unthread the swivel
GARDEN ™

Step 4: Loosen hex screw from crank handle shaft (located
)leerehtfoedisniehtno
**DO NOT REMOVE THIS HEX SCREW**
Step 5: Loosen black plastic locking ring and remove
.eldnahknarcottfahs
Step 3: Remove bolt and washer from crank handle and
remove the crank handle (located on the right side of reel)
.tfahsmorf
.emarfmorfdevomerylisaeebwondluohsleeR:6petS
Step 7: When the reel is turned, the elbow will now be on the
right side of the ree
.l
Step 8: Install swivel on right side of reel/frame and re-tighten
black plastic locking ring. ebotevahlliwleviwsehT
re-screwed into the elbow. Once installed, tighten hex screw to
.leernowoble/leviwsehtdloh
(*Plumbers tape may have to be reapplied to threaded side of
shaft)
,leviwsehtfodaeherauqsssarbehtevomerotdahuoyfI*
re-attach r pmalc- cehtgnisue
Step 9: Install shaft to crank handle on left side o dnaleerf
re-tighten black plastic l .gnirgnikco
Step 10: Tighten up the hex screw located on the inside of the
spoo .ediseldnahknarcnol
Step 11: Re- attach the crank handle to shaft, using washer
and s .werc