Lifegard Little TIME or TEMP Series User manual

Little
Digital Clock/Thermometer
with illuminating back light
Accurate measurement of Aquarium Water
or Room Temperature in °F or °C.
Use for... Aquariums
Reptiles
Green Houses
Wide temperature range –50°C to +70°C / –58°F to +158°F.
Safe for Salt or Freshwater use
Attaches to any surface
Heavy Duty Battery
2 Year Battery Life
3’ Cord with all plastic probe and suction cup. For salt or freshwater use.

Operating Instructions
Order #270778
Use pressure sensitive adhesive pad to attach to any flat surface.
Little
TIME
OR
TEMP
™
Remove sticker from face of thermometer.
To Install Battery: (Fig. A) Battery type: AAA.
Insert battery by sliding battery door open and
inserting battery in direction as indicated.
Back Light: Press and hold “LIGHT” button.
(Fig. B)
Water or Air Temp:
(Fig. B) Slide switch upward
to “AIR” for room temperature. Slide switch
downward to “WATER” for Aquarium temperature.
Place Probe with Suction Cup inside Aquarium or
Wet/Dry Filter. Fully submerge probe under water.
Do Not submerge meter or allow meter to get wet.
Damage may occur.
Clock: To read time, press and hold “CLOCK”
button. Release and display will return to
temperature mode. (Fig. B)
To Set Clock: (Fig. A)
1. Slide switch to clock position.
2. Press and hold “HR” button for 3 seconds.
Hour numbers will advance to desired hour.
3. Press and hold “MIN” button for 3 seconds. Minute
numbers will advance to desired positions.
4. Slide switch to “TEMP” position after clock setting.
To Set °C or °F: (Fig. A)
Slide switch upward for °C or downward for °F.
Fig. A
Fig. B
Email: [email protected]
www.lifegardaquatics.com