lifelong LLM99 User manual

#STRESSFREE
FOOT AND CALF
MASSAGER
Kneading, rolling and
vibrating actions
Preset and
manual modes
Washable
foot cloth

HOW TO USE
The Lifelong Foot and Calf Massager can give you effective foot massage to
your feet, ankles and calves all at the same time.
STEP 1: Ensure that the device is switched off before plug in
STEP 2: Put your feet and calves in the black cloth area
STEP 3: Switch on the device by sliding the switch to ON position
STEP 4: You can change the settings by clicking on this buttons.
STEP 5: It has 3 buttons to choose between Vibration & Heat, Manual and
Auto
STEP 6: The auto mode has 3 preset actions P1, P2 & P3
STEP 7: Switch to manual mode and adjust heat, vibration and speed on
calves and feet
Dear Customer
Congratulations on your Lifelong Purchase. Our name stands for high-quality
and thoroughly tested products. Please read these instructions carefully
before use.
CLEANING
•To clean the unplugged device after it has cooled down, wipe with a slightly
dry cloth. However, ensure that water never gets inside the device.
•The foot cloth can be removed from the zipper and washed separately
INSTRUCTION
•Ensure that the device is switched off before you plug in.
•Do not stand on, or exert excessive pressure on the massager, it can slow
down or stop the machine
•You may feel itchy while use. Do not worry as this is due to improved
circulation
•Do not use the massager while you’re in the washroom
•Do not use the massager on wet body, this may cause short circuit or electric
shock
•Those suffering from cancer, osteoporosis, tumors, high fever or pregnancy
must consult a doctor before use.
•Do not use the massager when it is in a bad condition
•Never operate the device especially if there are children in the vicinity.
•Do not use with animals or pets.
•Do not cover the massager with the damp cloth when it is in an operating
condition, it may result to a subsequent breakdown or fire

• Connect the device only to the type of voltage stated on the nameplate.
•Do not sleep while using the massager
As with every electrical device, this massage device should be used
carefully and cautiously in order to avoid the risk of electric shock:
•Unplug the mains cable immediately after use.
•Prevent any contact with water (except when cleaning with a slightly damp
cloth). Water must never get inside the device. Never submerge the device in
water. Never use the device in the bath, in the shower, in a swimming pool or
over a basin filled with water. However, if water gets inside the casing, unplug
the device immediately and contact customer service.
•The device and in particular the mains cable should be checked for any
damage before each use.
•Never plug the device into the mains power supply if the cable is damaged.
•Never hold or carry the device by mains cable.
•If a fault should occur during use, switch off the device immediately and unplug
it from the socket.
•The device is intended only for the purpose described in these instructions for
use. The manufacturer can accept no liability for injury arising from incorrect or
careless use.

Model No. LLM99
Voltage: AC 220V-240V
Power: 80W
Rated Working Time: 15 Minutes