lifestyle mobility aids KN1100 User manual

Knee Walker
KN1100

PARTS DIAGRAM
2

Tiller in Upright Position
1Disconnect the straps that hold the tiller/handle bar down.
2Move the handle towards upright position until it snaps into place.
Camlock in
locked position
ASSEMBLY INSTRUCTIONS
2
3
3Move camlock across bar until it locks into place.

2Adjust the seat height for user.
3Insert locking pin back into place and tighten the knob, making sure it is
securely in place.
1Release the camlock then remove the locking pin.
Locking pin
Camlock
Raise the knee pad up or down.
ADJUSTING KNEE PAD HEIGHT
4

1To engage the brakes, squeeze and hold the brake levers on both handles.
1To lock the brake, follow instructions above. Push and hold the button next to the brake
lever. If done properly, the button will remain pushed in and the lever will stay locked. Rear
wheels will stay in position when locked.
2To release the brake, squeeze lever and the push button will release.
1
Release the camlock then remove the locking pin.
Locking pin
Camlock
Brake
lever
Lock button
4
5
ENGAGING HAND BRAKE