Lifestyle Solutions HARRINGTON User manual

Place the left armrest as shown below, insert the metal plates on the
armrest to the one on the chaise body.
Ensure it is correctly in place.
8 of 8 Rev.10282016 TOLL FREE 877-693-8866 LIFESTYLE SOLUTIONS
HARRINGTON
11
If you want to place loveseat on left side and chaise on right side,
please follow the leg positions as shown below when assembling the
item.
12
Metal plate
on armrest
Metal plate
on chaise
Optional leg for
added support
Optional leg for
added support

PARTS AND HARDWARE
Avoid using sharp objects such as a knife to open packing as you may accidentally damage the upholstery.
2 of 8 7 of 8
Secure the back cushion by locating the open-ended zipper pin/box. Fasten
both sides and continue all the way to the end. Flip the back cushion into the
position when finished.
Lift the chaise and insert the metal plates on the chaise body into the metal
plates on the loveseat body.
Ensure it is correctly in place.
Leg
8x
Loveseat backrest
1x
Chaise Body
1x
Loveseat Body
1x
Back Cushion
3x
Back Cushion Cover
3x
Chaise backrest
1x
Arm
1 Pair
M10 Washer
(Outer Dim. 45mm)
8x
9
10
Metal plate
on loveseat
Metal plate
on chaise

6 of 8 3 of 8
ASSEMBLY INSTRUCTIONS
CAUTION: At least two adults are required to safely complete performing this task.
Other lifting attempts may risk back injury due to large and heavy part(s).
Carefully unpack parts/hardware from the storage of the chaise and loveseat body
and place on a clean flat surface.
Place the chaise body and chaise backrest as shown below, secure
legs and plastic washers into the pre-drilled holes on the bottom of each
part as shown. Please avoid overtightening.
Carefully lift and turn assembled parts onto its legs.
Insert the chaise body metal plates to the chaise backrest as shown below.
Ensure it is correctly in place.
Storage
Storage
Place the loveseat body, loveseat backrest and right armrest as shown below,
secure legs and plastic washers into pre-drilled holes on the bottom of each part
as shown. Please avoid overtightening.
1
7
8
2
Bracket on
chaise body
Bracket on
backrest

Secure the back cushions by locating the open-ended zipper pin/box. Fasten both
sides and continue all the way to the end. Flip back cushion into positions when
finished.
Carefully lift and turn assembled parts onto its legs.
Insert loveseat body metal plates to loveseat backrest as shown below.
Ensure it is correctly in place.
4 of 8 5 of 8
Insert the metal plate on the loveseat backrest and loveseat backrest to the
arm as shown below. Keep the arm rested on the ground while lifting sofa
loveseat up to connect brackets. Ensure it is correctly in place.
3
4
6
Metal plate
on armrest
Metal plate
on loveseat
Bracket on
loveseat body
Bracket on
backrest
NOTE: If chaise is used on left
facing side, the front right leg
under loveseat body is optional.
Unzip all the back cushion covers, insert the back cushions to the correct back cushion
covers, make sure the back cushions are flat in the covers.
5