LIGHTING Elements ATMOS User manual

ATMOS (RECESSED) USER MANUAL
Please read the manual carefully before installing the product and save
it for future reference.
The product has been well inspected on performance and complete packaging before shipment
from the factory. All users shall strictly observe the warning and operation instructions stated in
this manual. Any damage caused by misoperation is not within the warranty, and the failures
and problems caused by not following the operating manual are not in the responsibility of the
distributor.
Installation Diagram
Installation procedure
1. Shut “OFF” the electricity at main fuse box.
Place the wall switch in the “OFF” position of the room you are installing the fixture.

2.Cut out a hole, the hole size refer to picture below:
3.Take out the fixture from the packing box. To ensure that fixture are complete, Use wire
connectors to connect L,N,G,DIM+,DIM- wires. After finish, Put all Wires with connector
into Driver Box. Then connect flexible conduit from Driver Box.
4.Make the fixture upward and turn the clip vertical, let the clip enter the ceiling hole. Then
relax the clip, refer to picture below.

5. Turn electricity “ON” at main fuse box. Place the single pole switch in the “ON” position
to light on the fixture.
Warnings
● MIN 90 °C SUPPLY CONDUCTORS/LES FILS D’ALIMENTATION 90 °C MIN
● DAMP LOCATIONS ONLY/POUR EMPLACEMENTS SECS SEULEMENT
● CAUTION – RISK OF FIRE/ATTENTION – RISQUE D’INCENDIE
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION
CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED/CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE
D’INSTALLATION PERTINENT, PAR UNE PERSONNE QUI CONNAÎT BIEN LE PRODUIT ET SON
FONCTIONNEMENT AINSI QUE LES RISQUES INHÉRENTS
● Application temperature for ring light is -20℃~40℃，humidity is 0~95％. Otherwise there
may be harm to the lifespan of the ring light.
● Please TURN OFF POWER before installation. This lamp must be installed and maintained by

electrician or qualified personnel.
● Pay attention to fire prevention, electricity and shock resistance.
● Please do not cover the combustibles on the fixture.
● All screws and terminals should be tightened and tightly inserted. No loosening and improper
connection are allowed. Attention should be paid to the polarity of components, power supply,
driver and so on.
● Terminals should be tightened and tightly inserted. No loosening and improper