Lightolier LYTECASTER 1029 SERIES User manual

r
READAND UNDERSTANDTHESEINSTRUCTIONSBEFOREINSTALLINGFIXTURE INSTRUCTION SHEET NO.
“his fixture is intendedfor installationin accordana+with the National ElectricalCode and local
emulations. To assure full compliance with local codes and regulations, check with your local electrical
mpectorbefore installation. Toprevent electrical shock, turn off electricity at fuse box before proceeding. IS:1029
Retainthese instructions for maintenancereference. 0892
INSTALLATION PROCEDURE OF LYTECASTER 1029 SERIES REFLECTOR TRIMS
IN THE 1000PI FRAME-IN KIT
WARNING: READMARKINGSINTRIMTO DETERMINELAMP
WAllAGE ANDTYPE,ALWAYSUSECORRECTLAMP.
1. FRAME-IN
SeeFrame-In Kit Instruction Sheet for installation procedure.
2. ROTATE ROTO-CLIPS (Fig. A)
Rotate (3) ROTO-CLIPS so that the short legs extend inwardly toward the
center opening.
3. TRIM INSTALLATION
A. Inserl SOCKET SPRING into SLOTS in neck of REFLECTOR. (Fig. B)
B. Push REFLECTOR TRIM straight up into ceiling opening until it is tight
against ceiling.
C. Lamp fixture with recommended lamp wattage and type. (See wattage
label,)
D. Vertical adjustment can be done by inserting ascrewdriver into slot in
YOKE, and using it as alever, tilting the YOKE to the desired angle.
(Fig. C.)
E. Horizontal adjustment can be done by rotating LAMP/YOKE to desired
position.
NOTE:To remove Reflector Trim, turn Reflector Trim counterclockwise
while pulling downward.
10OOP1 also accepts the following reflector Trims: 1005, 1008, 1010, 1011,
1012,1013, 1013BK, 1013WH, 1021,1022, 1023,1024,1035,1045, 1046,
1071, 1076, 1076WH, 1078, 1082, 1085, Rotate ROTO CLIPS so that the
LONG LEGS extend inwardly toward the center opening.
WARNING: USEONLYWITHFRAME-INKITSPROVIDEDBY
LIGHTOLIERINC.USEOFOTHERMANUFACTURERS’FRAME-
INKITSVOIDSTHE UNDERWRITERSLABORATORIESLISTING
ANDCOULDCONSTITUTEAFIREHAZARD.
LONGLEG
(w[thReturn)
SHORTLEG ~ROTOCLIP(4)
\$ \]:_
FIG. A
1- I<>1-1 i<> 14 Ela” ~i’%?~;::y~:::!